Abstract:Nowadays, it is critical to find materials and methods that can help reduce the human impact on the environment. Regenerative thermal oxidizers (RTOs) have a wide range of applications owing to their effective energy saving. Among the different RTOs, thermal-storage RTO ceramics have basic heat storage and release capability. The main objective of this work is to study the preparation of thermal-storage RTO ceramics for the treatment of exhaust gas using bauxite tailings and Bayer red mud from Jiaozuo City (Henan Province) with different mass fractions of magnetite as substitutes for the traditional raw materials (quartz and clay). The effect of the magnetite addition on the performance of the thermal-storage RTO ceramics prepared from the bauxite tailings and red mud was investigated. The raw materials were pressed into cylinder shape and then sintered at 950 °C, 1000 °C, 1050 °C, and 1100 °C. The developed materials were analyzed and characterized via X-ray diffraction and scanning electron microscopy, and specific heat capacity tests (differential scanning calorimetry using the sapphire method) were conducted on the thermal-storage RTO ceramics prepared at the optimal sintering temperature (1050 °C). The ceramics exhibit the best overall performance for magnetite content of 25% and sintering temperature of 1050 °C, with compressive strength of 134.96 MPa, volume density of 3.00 g/cm3, and linear shrinkage of 14.68%. The product also has a remarkably low water absorption rate and apparent porosity, water absorption of 0.02%, apparent porosity of 0.06%. Furthermore, the specific heat capacity is sufficiently high to meet the requirements of high-thermal-storage RTO ceramics. This study provides a new, low-cost solution for the preparation of high-thermal-storage RTO ceramics, which is helpful for reducing the exploitation of natural mineral resources.

High-temperature Mechanical Behavior and Thermal Shock Resistance of Eco-Friendly Periclase-Mg1.08al1.84ti0.08o4 Spinel Refractories Used in RH Degassing Process

Fabrication of Y2O3-doped MgO Refractory Raw Materials Based on Magnesium Hydroxide from Salt-Lake Brine

Investigation on mechanical and thermal properties of MgAl2O4-Mg2TiO4 solid solutions with spinel-type structure

A Comparative Study of Corrosion Behavior of MgO-based Refractories in RH Snorkels: MgO-sintered MgAl2O4 Refractories and MgO-synthetic Mg1.08Al1.84Ti0.08O4 Refractories

Improved properties of in-situ MgAl2O4-TiO2 dense layer reinforced low-carbon MgO-based refractories

Improved thermal shock resistance of MgO–C refractories with addition of calcium magnesium aluminate (CMA) aggregates

Influence of titania on sintering and thermal expansion property of periclase spinel unfired product

High-temperature performance in Al2O3–Cr2O3 refractories: Effect of Al2TiO5

Fabrication and thermal shock behavior of periclase-forsterite aggregates with micro-nanometer dual-pore-size structures

The microstructure evolution and performance enhancement of MgO-C refractories by the addition of MA90 spinel micro-powder

A novel low thermal conductivity refractory aggregate for high-temperature applications: Lightweight microporous alumina-rich spinel (Mg0.4Al2.4O4)

Thermodynamic calculation and microstructure characterization of spinel formation in MgO–Al2O3–C refractories

Enhanced thermal shock resistance of hydratable magnesium carboxylate bonded castables via in-situ formation of micro-sized spinel

Mechanism of in-situ formation of spinel and its effect on the mechanical properties of Al2O3–C refractories

Mechanical Behavior and Thermal Shock Resistance of MgO-C Refractories: Influence of Graphite Content

Fabrication and properties of high-thermal-storage RTO ceramics using bauxite tailings and red mud

Simultaneous enhance of the thermal shock resistance and slag-penetration resistance for tundish flow-control refractories: the role of microporous magnesia

Microstructure evolution, mechanical characteristics and erosion behavior of Cr2O3–Al2O3–MgO–ZrO2 refractories in molten reduction slag

Quantitative Assessment of Microporous MgO Castable Erosion and Corrosion Behaviors in Two Tundish Covering Fluxes

Reaction of a Molten Cr-Si-Base Alloy with Ceramics and a High Entropy Oxide

Development of an Ultra-Low Carbon MgO Refractory Doped with α-Al2O3 Nanoparticles for the Steelmaking Industry: A Microstructural and Thermo-Mechanical Study