Abstract:The glass‐to‐mold adhesion in precision glass molding could severely degrade the quality of molded optics and shorten the lifespan of the precious molds. Since the consequences of adhesion take effect during the separation between glass and molds, it is important to investigate the debonding behaviors of a typical glass molding interface. To this end, here we perform a probe tack test procedure for borosilicate glass BK7, where debonding is conducted at molding temperature and specific velocity. We fully characterize the debonding behaviors by using the peak adhesion stress σmax and the work of debonding Wdeb. Experiments show that when temperature is decreased from 690 °C to 655 °C at 10 µm/s, σmax continuously increases, while Wdeb first increases but then sharply decreases. When the debonding velocity is increased from 10 µm/s to 50 µm/s at 680 °C, σmax also increases while Wdeb overall decreases. Therefore, the debonding behaviors are highly temperature and rate dependent. More importantly, depending on the debonding conditions, three debonding types are identified, i.e., the cohesive bulk deformation, the cohesive‐interfacial transition and the interfacial fracture. The cohesive type can be converted into the interfacial fracture, by either decreasing temperature or increasing the debonding velocity. Based on the Wdeb criterion, the three debonding regimes can be clearly distinguished. Finally, analyses on the temperature and velocity experimental results are unified by incorporating the reduced crack velocity ɑTνc. The dependences of both viscoelasticity and Wdeb on ɑTνc qualitatively explain the transition condition for different debonding types. Concerning these findings, the work of debonding not only supplements the characterization of adhesion strength, but also throws insightful light on revealing the debonding mechanisms.

Study on the Deformation During Laser-Assisted Glass Frit Bonding Process

Laser Bonding of Glass and Glass with Constant Temperature Output

FEM Analysis of Hot-Pressing Process of Aspheric Glass P-SK57 Lens

Finite Element Analysis on Non-Isothermal Glass Molding

Measure for optical robustness of directly bonded glass-to-glass joint using its interaction with damage induced by fs laser

The effect of gap on the quality of glass-to-glass welding using a picosecond laser

Temperature and rate dependent debonding behaviors of precision glass molding interface

Infrared Laser Heating of GFRP Bars and Finite Element Temperature Field Simulation

Diffusion Bonding of a Zr-based Metallic Glass in Its Supercooled Liquid Region

Field-assisted Titanium-Glass Bonding.

Investigation of glass bonding and multi-layer deposition during filament-based glass 3D printing

Characterization of Morphology and Mechanical Properties of Glass Interior Irradiated by Femtosecond Laser

Optimized Sealing Process And Real-Time Monitoring Of Glass-To-Metal Seal Structures

Energy-dependent correlation between micro/nano-morphology and stress state of femtosecond laser-induced modification in fused silica

In Situ Characterization of Residual Stress in Glass-to-metal Seal

An Experiment to Test the Mechanical Losses of Different Bonding Techniques in Fused Silica

Research on the interfacial microstructure and mechanical properties of glass/Mg joint prepared by anodic bonding and vacuum diffusion bonding

Finite Element Analysis of Weld Area in Spot Bonding Process to Predict Bond Strength in Transparent Materials Using Ultrafast Lasers

Study on 532nm and CO2 laser processing of fused silica glass

Numerical Analysis of the Temperature Field during Single-pass Two-layers Laser Additive Manufacturing of Fused Silica Glass

Innovative laser-assisted glass bending approaches using a near-infrared continuous wave laser