Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter

Current Saturation Analysis and Anti-Windup Control Design of Grid-Forming Voltage Source Converter

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

Optimal short‐circuit current control of the grid‐forming converter during grid fault condition

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Dynamic Current Limiting of Grid-forming Converters for Transient Synchronization Stability Enhancement

Adaptive Control Strategy for Grid-Based Energy Storage Converter under Frequency Disturbance

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Current-Synchronization Control of Grid-Forming Converters for Fault Current Limiting and Enhanced Synchronization Stability

Active Power and Voltage Cooperative Control for Improving Fault Ride-Through Capability of Grid-Forming Converters

Active Power Enhancement Control Strategy of Grid-Forming Inverters Under Asymmetrical Grid Faults

Reactive Power Characteristics and FRT Strategy for Grid-Forming Converters with Virtual Impedance-Based Current Limiting

Adaptive Supplementary Control of VSG Based on Virtual Impedance for Current Limiting in Grid-Connected and Islanded Microgrids

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Improved Dynamic Response in Grid-Forming Converters with Current Limiting Control during Fault Conditions

Dc-Voltage Fluctuation Elimination Through A Dc-Capacitor Current Control for Dfig Converters under Unbalanced Grid Voltage Conditions

Control of Grid-Forming VSCs: A Perspective of Adaptive Fast/Slow Internal Voltage Source