Abstract:The behaviour of Polymer Electrolyte Membrane Fuel Cells (PEMFC) shows a complex, non-linear dependence on material properties and operation conditions. Therefore, modelling and model parameterization by electrochemical characterization of PEMFCs is challenging. To deconvolute the different loss mechanisms in PEMFCs, impedance spectra are recorded and modelled by equivalent circuit models. Transmission Line Models (TLMs) are a well-established, physicochemical approach for modelling the impedance of PEMFC electrodes. TLMs consider the processes occurring in an electrode and the model parameters are directly related to material and microstructural characteristics. PEM electrodes have inhomogeneous distributions of the material, the current density, stored water, etc. Assuming a homogeneous electrode with homogeneous current distribution, the basic TLM shown in [1] turned during impedance fitting out to be inaccurate in operation conditions where these assumptions do not hold. To increase the fit accuracy, literature proposes a number of adapted TLMs. These TLMs have additional components and therefore degrees of freedom. This enables these models to take additional processes and the microstructure into consideration. In this contribution an incremental 1 cm2 PEMFC ensuring zero gradient operation is characterized by means of impedance spectroscopy. Different operating conditions are varied within wide ranges and additional characterization methods, like H 2 /N 2 operation were applied. Different TLMs proposed in literature are evaluated by fitting them to the measured spectra with and without considering the information gained from additional measurements. The DRT was applied as additional criteria in the fitting. In general, the accuracy of a fit increased with the number of free fitting parameters. Thus more complex TLMs accounting for additional physicochemical processes provide a lower error in the fit. Nevertheless the physicochemical meaningfulness of the determined model parameters is sometimes uncertain. It will be shown that for a meaningful parameterization by CNLS-fitting such TLMs require additional tests and characterization methods. [1] Heinzmann Marcel; Weber André; Ivers-Tiffée Ellen. „Impedance modelling of porous electorde structures in polymer electrolyte membrane fuel cells“. In: Journal of Power Sources (2019).

Study on Relationship Between Low-Frequency Impedance and Internal States of Polymer Electrolyte Membrane Fuel Cell Based on Mass Transfer and Impedance Model

Modeling Analysis of Polymer Electrolyte Membrane Fuel Cell with Regard to Oxygen and Charge Transport under Operating Conditions and Hydrophobic Porous Electrode Designs

Impedance Characteristics of Cell-to-Cell Inconsistency of Polymer Electrolyte Membrane Fuel Cells

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

In-situ Impedance Diagnosis Experiment and Equivalent Circuit Modeling Based on Distribution of Relaxation Time Method for Unitized Regenerative Proton Exchange Membrane Fuel Cells

Pseudo-Steady State of High-frequency Resistance for Polymer Electrolyte Membrane Fuel Cell: Effect of In-Plane Heterogeneity

Diagnosis of Water Failures in Proton Exchange Membrane Fuel Cell with Zero-Phase Ohmic Resistance and Fixed-Low-frequency Impedance

Electrochemical Impedance Analysis with Transmission Line Model for Accelerated Carbon Corrosion in Polymer Electrolyte Membrane Fuel Cells

Recent progress in the use of electrochemical impedance spectroscopy for the measurement, monitoring, diagnosis and optimization of proton exchange membrane fuel cell performance

Electrochemical Pressure Impedance Spectroscopy for Polymer Electrolyte Membrane Fuel Cells: Signal Interpretation

Analyze the Effects of Flow Mode and Humidity on PEMFC Performance by Equivalent Membrane Conductivity

A new insight into the effects of agglomerate parameters on internal dynamics of proton exchange membrane fuel cell by an advanced impedance dimension model

A Detailed Analysis of Internal Resistance of a PEFC Comparing High and Low Humidification of the Reactant Gases

Uncoupling Characteristics Of Temperature And Relative Humidity Distribution In A Commercial-Size Polymer Electrolyte Membrane Fuel Cell

Simulation of Water Transport in Proton Exchange Membrane Fuel Cell Using a One-dimension Model

Analysis of Transmission Line Models for PEMFC Impedance Modelling

Analysis of Impedance, with Different Discharge Current in Proton Exchange Membrane Fuel Cell

Evolution and mechanism of impedance in PEMFC induced by cathode ammonia contamination

Analysis of the influence of cathode recirculation strategy on proton exchange membrane fuel cell from internal polarization and external characteristics perspectives

Unveiling the Mechanisms Behind Temperature-Dependent Impedance Behavior in Polymer Electrolyte Fuel Cells at High Current Loads

The Optimization of PEM Fuel Cell Performance Using the CFD Method Combined with Experimental Validation