Effect of cathode relative humidity on membrane water content and performance of PEMFC

YU Yongshuai,LIU Yongfeng,PEI Pucheng,ZHANG Lu,YAO Shengzhuo

DOI: https://doi.org/10.19799/j.cnki.2095-4239.2023.0048

2023-01-01

Abstract:The proton exchange membrane fuel cell （PEMFC） must ensure sufficient hydration of the proton exchange membrane during operation， and it must also avoid condensed liquid water blocking the mass transfer channel. In order to analyze the effect of cathode relative humidity on the membrane water content and output performance of proton exchange membrane fuel cells， the cathode inlet water content （CIWC） model was established. Firstly， the influence of membrane resistance by temperature and water content is considered in this model， the water content calculation formula of the membrane is derived， and the CIWC model is coupled to the computational fluid dynamics software Fluent for calculation. Secondly， a fuel cell test bench was built to conduct experiments when the operating temperature was 60 °C， the relative humidity of the anode was 100%， and the relative humidity of the cathode was 50%， 75% and 100%， respectively. Finally， the simulated data of CIWC model and Fluent built-in model are compared with the experimental values， and the species distribution of membrane water content， membrane conductivity， and molar fraction of water in the catalytic layer were analyzed on the cathode side. The results show that when the cathode relative humidity is 50%， the accuracy of the CIWC model is improved by 17.67% compared to the Fluent model at a voltage of 0.739 V. The maximum relative error between the CIWC model and the experimental value is 5.66% at 100% cathode relative humidity. With the increase of the relative humidity of the cathode， the membrane water content increases continuously at a voltage of 0.75 V and tends to be saturated at a voltage of 0.6 V， and the membrane water content， the proton conductivity and the molar fraction of the water in the catalytic layer gradually increase in the direction of the flow field from the air inlet to the outlet. When the cathode relative humidity is 75%， the fuel cell output power density is up to 272.08 mW/cm 2 ， and the distribution of membrane water content is more uniform.