Abstract:3D Concrete Printing (3DCP) is considered a solution to confront both labor shortages and material waste in the construction industry. However, to realize non-standard, large-scale buildings, substantial amounts of supporting material and manual assembly are still required to print structures with significant overhangs, including the inclined structure and the cantilever structure. In response, the study draws inspiration from mushroom lamellae and proposes a geometry-based approach to adjusting the large-overhang shape into a self-supported one. This approach imitates lamella morphology by creating folds on the given geometry based on constraints established through empirical studies, thereby reducing overhangs and improving printability. Specifically, the proposed approach includes two shape variation methods. The first method generates lamellae perpendicular to the inclined shape, thereby providing lateral support to the filament. The second method creates lamellae under the cantilever, facilitating a seamless horizontal-to-vertical transition. The effectiveness of these methods is demonstrated through the generation and printing of four column capital samples. Upon evaluating the overhang mechanisms of these geometries, an approachable optimization method is also presented to further minimize the amplitude of lamellae while maintaining self-supporting ability. Compared with control groups that focus on either maximizing printability or minimizing material usage, the optimal result for the inclined structure prototype showcases an over 75 % overhang reduction on the critical layer with just about 15 % use of additional material. As for the cantilever prototype, an over 75 % overhang reduction is achieved on the critical layer with about 35 % additional material usage. Various large-scale structure examples are presented at the end of the research, illustrating the applicability and scalability of the lamella-inspired method in a wider range of building types.

Improving the Overhang of 3D-Printed Concrete Shells by Wrinkle Structures

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Design and Validation of 3D Self-Supporting Structures and Printing Paths for Multi-Axis Additive Manufacturing

Self-Supporting Lamellae: Shape Variation Methods for the 3D Concrete Printing of Large Overhang Structures

Research on Mechanical Properties of a 3D Concrete Printing Component-Optimized Path by Multimodal Analysis

Inclined 3D concrete printing: build-up prediction and early-age performance optimization

3D printing concrete structures: State of the art, challenges, and opportunities

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

Buildability analysis on squared profile structure in 3D concrete printing (3DCP)

The Impacts of Fabrication Systems on 3D Concrete Printing Building Forms

Buildability Analysis of 3D Concrete Printing Process: A Parametric Study Using Design of Experiment Approach

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

The Influence of Three-Dimensionally Printed Polymer Materials as Trusses and Shell Structures on the Mechanical Properties and Load-Bearing Capacity of Reinforced Concrete

3D Printing Concrete on temporary surfaces: The design and fabrication of a concrete shell structure

Interfacial Properties of Three-Dimensional-Printed Permanent Formwork with Cast-in-Place Concrete

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

Internal topology optimisation of 3D printed concrete structures: a method for enhanced performance and material efficiency

An integrated topology optimization method including manufacturing constraints for 3D printed fiber-reinforced concrete structures

3D concrete printing modelling of thin-walled structures

3D Printed Concrete Walls Reinforced with Flexible FRP Textile: Automatic Construction, Digital Rebuilding, and Seismic Performance