Abstract:The risk of titanium fire increases significantly with the development of future aero-engine, however, the burning mechanisms of titanium alloys remain uncertain. Therefore, the ignition behaviors and mechanisms of near α high-temperature titanium alloy are studied in this paper by employing an integrated experiment method, including laser-oxygen concentration ignition method, infrared temperature measurement and observation of molten metal by high-speed camera. Based on this, the ignition boudary curve is determined and the ignition temperatures of the alloy are found to decrease from 1610 to 1550 °C with the increasing of laser power from 200 to 325 W and of oxygen concentration from 21% to 60%. The ignition microstructure was characterized by FIB and TEM to study the evolution of reaction products. Pores are found to form under the TiO 2 surface layer, which can be attributed to the instablity of TiO. The failure mechanism of protective oxide layer is further analyzed according the oxide layer damage model caused by thermal stress. As temperature approaches the ignition temperature, which locates below the melting point, the high vapor pressure of TiO causes the formation of porous defects under the TiO 2 surface, thus accelerating the fracture and failure of the TiO 2 layer under thermal stress. It is revealed that critical conditions of temperature and instantaneous temperature change rate are both required to fulfill the ignition. Based on this, an ignition model is futher constructed to discuss the relationship among ignition temperature, laser power and oxgyen concentration. According to the experimental data fitting, the reaction activation energy of TA19 alloy during the ignition stage is calculated as approximately 300 kJ/mol, and the function for ignition temperature calculation is concluded as 8.3×10 9 e -300000/R T ig c 1/2 +0.52 P L -331=0. This provides a theoretical reference for predicting the ignition temperatures of near α high temperature titanium alloy and other types of titanium alloys under complex airflow conditions in aircraft engines.

Ignition Sensitivity and Flame Propagation of Titanium Powder Cloud

Experimental Study of Flame Propagating Behaviors Through Titanium Particle Clouds

Effects Investigation of Particle Size and Concentration on the Ignition, Explosion Characteristics, and Behavior of Flame Propagation in TC4 Titanium Alloys

Minimum Ignition Temperatures and Explosion Characteristics of Micron-Sized Aluminium Powder

Flame structures and particle-combustion mechanisms in nano and micron titanium dust explosions

Characterization of Ti powders mixed with TiO<sub>2</sub> powders: Thermal and kinetic studies

Research of Minimum Ignition Energy for Nano Titanium Powder and Nano Iron Powder

Flame Propagation Behaviors and Influential Factors of TiH2 Dust Explosions at a Constant Pressure

Mechanosynthesis Mechanism of Tic Powders

Ignition Temperature and Mechanism of Carbonaceous Dust Clouds: the Roles of Volatile Matter, CH4 Addition, O2 Mole Fraction and Diluent Gas.

Ignition Resistance Performance and Its Theoretical Analysis of Ti-V-Cr Type Fireproof Titanium Alloys

Study on the Ignition Mechanism of near α High Temperature Titanium Alloy

Measurement Of Ti-6al-4v Alloy Ignition Temperature By Reflectivity Detection

Study on inhibition of explosion of titanium powder by mesoporous calcium compound/carbonized chelating resin composite powder

Flame Propagation Characteristic of Zirconium Particle Cloud

Combustion Microstructures and Frictional Ignition Resistance of Ti-6Al-4V Titanium Alloy

Suppression Effects and Mechanisms of Three Typical Solid Suppressants on Titanium Hydride Dust Explosions

Phases of Titanium Combustion in Air

Flame phenomena in nanogrinding process for titanium and iron

Effect of particle size polydispersity on the minimum ignition temperature of PMMA dust clouds

Exploring the Combustion Mechanism of Single Micron-Sized Aluminum Particles with a Numerical Model