Abstract:Purpose: Silicon diode arrays are commonly implemented in radiation therapy quality assurance applications as they have a number of advantages including: real time operation (compared to the film) and high spatial resolution, large dynamic range and small size (compared to ionizing chambers). Most diode arrays have detector pitch that is too coarse for routine use in small field applications. The goal of this work is to characterize the two-dimensional monolithic silicon diode array named "MagicPlate-512" (MP512) designed for QA in stereotactic body radiation therapy (SBRT) and stereotactic radio surgery (SRS). Methods: MP512 is a silicon monolithic detector manufactured on ap-type substrate. An array contains of 512 pixels with size 0.5×0.5 mm2 and pitch 2 mm with an overall dimension of 52×52 mm2. The MP512 monolithic detector is wire bonded on a printed circuit board 0.5 mm thick and covered by a thin layer of raisin to preserve the silicon detector from moisture and chemical contamination and to protect the bonding wires. Characterization of the silicon monolithic diode array response was performed, and included pixels response uniformity, dose linearity, percent depth dose, output factor, and beam profiling for beam sizes relevant to SBRT and SRS and depth dose response in comparison with ionization chamber. Results: MP512 shows a good dose linearity (R2=0.998) and repeatability within 0.2%. The measured depth dose response for field size of 10×10 cm2 agreed to within 1.3%, when compared to a CC13 ionization chamber for depths in PMMA up to 30 cm. The output factor of a 6 MV Varian 2100EX medical linac beam measured by MP512 at the isocenter agrees to within 2% when compared to PTW diamond, Scanditronix point EDD-2 diode and MOSkin detectors for field sizes down to 1×1 cm2. An over response of 4% was observed for square beam size smaller than 1 cm when compared to EBT3 films, while the beam profiles (FWHM) of MP512 match to within 2% the data measured by radiochromic film. Conclusions: The response of the 2D detector array, MP512, has been evaluated. The properties of the array demonstrated suitability for use as in phantom dosimeter for QA in SRS and SBRT. Although MP512 matches film measurements down to 1×1 cm2 well, it showed a discrepancy of 4% in the determination of output factors of beams smaller than 0.5×0.5 cm2 due to the field perturbation generated by the large amount of silicon surrounding the central diode. MP512 is highly capable of measuring beam size (FWHM) and has a discrepancy of less than 1.3% when compared to EBT3 film. A reduction in the detector pitch to less than 2 mm would improve the penumbra reconstruction accuracy at the cost readout electronics complexity.

Three-dimensional semiconductor detector array ArcCHECK for radiation detection and quality assurance of medical linear acceleration

SU-FF-T-174: A New Device for the Verification of Temporal Function of the 4DCT and Gating Delivery System

The characteristics and clinical application of the ArcCHECK diode array for volumetric-modulated arc therapy verification

Evaluation of the ArcCHECK QA System for IMRT and VMAT Verification

SU‐E‐T‐190: Measuring Patient Cone Beam CT Dose Using a Commercial 4D Diode Array

Implementation and validation of 2-D-array based tests in routine linac quality assurance

Multileaf Collimator Modeling and Commissioning for Complex Radiation Treatment Plans Using 2-Dimensional (2D) Diode Array MapCHECK2

A virtual phantom for patient‐specific QA On A 1.5T MR‐linac

Evaluation Of The Sensitivity Of Two 3d Diode Array Dosimetry Systems To Setup Error For Quality Assurance (Qa) Of Volumetric-Modulated Arc Therapy (Vmat)

Application of 2-D Ionization Chamber Array For Validation of Electron Arc Therapy Plan

Comparisons of volumetric modulated arc therapy (VMAT) quality assurance (QA) systems: sensitivity analysis to machine errors

The Angular Dependence of a 2-Dimensional Diode Array and the Feasibility of Its Application in Verifying the Composite Dose Distribution of Intensity-Modulated Radiation Therapy

Identical Quality Assurance for Volumetric Modulated Arc Therapy in Elekta and Varian Machines

A beam range monitor based on scintillator and multi-pixel photon counter arrays for heavy ions therapy

Research on verifications of physical parameters of virtual wedge on Siemens accelerator by Mapcheck

SU‐E‐T‐188: an Effective Quality Assurance Method for TomoTherapy Craniospinal Irradiation Patients with A 3D Semiconductor Phantom

Validation of an improved helical diode array and dose reconstruction software using TG-244 datasets and stringent dose comparison criteria

The application of a 2D diode array in verifying the composite dose distribution of intensity modulated radiation therapy

Empirical Model for a Three-Dimensional Dose Verification System and Its Application in Volumetric-Modulated Arc Therapy for Heterogeneous and Long-Target Tumors

A two dimensional silicon detectors array for quality assurance in stereotactic radiotherapy: MagicPlate-512

Angular correction methodology and characterization of a high-resolution CMOS array for patient specific quality assurance on a robotic arm linac