Abstract:The shutdown process is one of the critical stages when the proton exchange membrane fuel cell system runs as an actual application. Finding the effect of system operating conditions on shutdown purging could improve the purging effect of liquid water and the dehydration of the stack. In this study, an automotive fuel cell system of 350 single cells was developed on the vehicle scale and tested for factors that influence shutdown process. Seven shutdown purge cases for about 150 s were studied to investigate the shutdown purge strategy. It was found that 100% bypass valve opening reduced the purge time and improved the purge ef-ficiency. The HCP speed should not be too slow or too fast in the shutdown process. The higher temperature of coolant water favored rapid shutdown and purge, and a large stoi-chiometric ratio of the cathode inlet improved the purge effect but enhanced the energy consumption of the air compressor. Neither too high nor too low purge pressure could blow out the liquid water more efficiently and improve the ohmic resistance. During purging, current density mainly influenced the water production rate and the maintenance state of stack temperature. With a higher stack temperature, purge process with a small current density could quickly reduce the stack humidity and enhance the ohmic resistance. Accel-erating the opening rate of the anode purge valve could not effectively accelerate purge effect of the stack, while extending the valve closing time could improve hydrogen utilization. Future studies to investigate the combined impact of these factors on the fuel cell system shutdown purge will be carried out to develop the most effective strategy.& COPY; 2023 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Mechanism Analysis and Application for the Temperature Difference-Assisted Purge Strategy on Shutdown Purge for Pemfc

An Effective PEMFC System Shutdown Purge Strategy for Improving the Purging Effect of Liquid Water and the Dehydration of Stack

Comprehensive Analysis of Shutdown Purge Influencing Factors of Proton Exchange Membrane Fuel Cell Based on Water Heat Transfer and Water Vapor Phase Change Mechanism

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

Numerical Simulation on Gas Purge After Shutdown in Proton Exchange Membrane Fuel Cell

Analysis and control strategy design for PEMFC purging process

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

Numerical Study on the Mechanism of Water and Gas Phase Transition and Water Redistribution after Purging Based on Two-Dimensional Multi-Phase Model

Study of the Two-Phase Dummy Load Shut-Down Strategy for Proton Exchange Membrane Fuel Cells

Modeling of the Operation Conditions on the Gas Purging Performance of Polymer Electrolyte Membrane Fuel Cells

Numerical Analysis of Static and Dynamic Heat Transfer Behaviors Inside Proton Exchange Membrane Fuel Cell

Two-Dimensional simulation of purge processes for dead-ended H 2 /O 2 proton exchange membrane fuel cell

Modeling Study of Anode Water Flooding and Gas Purge for PEMFCs

Control-oriented modeling of gas purging process on the cathode of polymer electrolyte membrane fuel cell during shutting down

Performance Degradation and Strategy Optimization of PEMFCs Under Sub-freezing Temperature

Numerical Study of the Gas Purging Process of a Proton Exchange Membrane Fuel Cell

Research on Control Algorithm of Proton Exchange Membrane Fuel Cell Cooling System

Control-Oriented Modeling of Purging Process and Cold Start of Proton-Exchange Membrane Fuel Cell

Three‐dimensional Modeling of Gas Purge in a Polymer Electrolyte Membrane Fuel Cell with Co‐flow and Counter‐flow Pattern

Numerical study of vapor behavior in high temperature PEM fuel cell under key material and operating parameters