Abstract:Proton exchange membrane fuel cells (PEMFCs) with the dead-ended anode (DEA) and dead-ended cathode (DEC) can achieve high utilization of hydrogen and oxygen but also cause the accumulation of liquid water in the cell and performance degradation. In this study, a two-dimensional multiphase transient PEMFC model is developed to investigate the purge strategy of the PEMFC with DEA and DEC. This model is well validated with the experimental data. The simulation results show that the voltage increases to a certain extent at the beginning of the dead-ended operation and then decreases gradually. During the purging period, the voltage reaches a peak value and then decreases. Therefore, the optimal purge duration is defined as the purge stops when the voltage reaches the maximum value, and the optimal purge duration decreases with the increase of scavenging velocity and increases with the increase of voltage drop rate, however, the energy efficiency under the optimal purge duration is not the highest. Besides, compared with the purging anode and cathode operation, the peak value of the purging cathode operation decreases gradually. Compared with the counter-flow operation, the co-flow operation leads to earlier purging moment, larger ohmic resistance, and voltage decay rate. The excessive accumulation of liquid water leads to a more poor uniformity of the local current density distribution. The purging cathode and counter-flow operation is the most ideal purge strategy during short-time operation, due to the highest energy efficiency about 52.3%, the second-highest output performance, and the second-longest purge interval about 180.01 s.

Control-oriented modeling of gas purging process on the cathode of polymer electrolyte membrane fuel cell during shutting down

Control-Oriented Modeling of Purging Process and Cold Start of Proton-Exchange Membrane Fuel Cell

Analysis and control strategy design for PEMFC purging process

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

A Pem Fuel Cell Model for Cold-Start Simulations

Comparison of Self-Humidification Effect on Polymer Electrolyte Membrane Fuel Cell with Anodic and Cathodic Exhaust Gas Recirculation

Two-Dimensional simulation of purge processes for dead-ended H 2 /O 2 proton exchange membrane fuel cell

Modeling and analysis of water vapor dynamics in high-temperature proton exchange membrane fuel cell coupling gas-crossover phenomena

An exhaust gas purging control algorithm based on fuzzy method for PEMFC

Optimization of purge strategy under fuel cell startup conditions based on CFD-Simulink collaborative simulation

Modeling of Two-Phase Transport in Proton Exchange Membrane Electrolyzer Cells for Hydrogen Energy

Dynamic Performance of a High-Temperature PEM (proton Exchange Membrane) Fuel Cell – Modelling and Fuzzy Control of Purging Process

Water-gas two-phase transport behavior and purge strategy optimization during mode-switching of unitized regenerative proton exchange membrane fuel cell

Water management in a self-humidifying PEM fuel cell system by exhaust gas recirculation

Analysis of the influence of cathode recirculation strategy on proton exchange membrane fuel cell from internal polarization and external characteristics perspectives

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Polymer Electrolyte Membrane Fuel Cell Transient Voltage Characteristic Considering Liquid Water Imbibition and Drainage in Gas Diffusion Layer

Nonlinear Dynamic Mechanism Modeling of a Polymer Electrolyte Membrane Fuel Cell with Dead-Ended Anode Considering Mass Transport and Actuator Properties

Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding

Modelling a polymer electrolyte membrane fuel cell system with anodic and cathodic exhaust gas recirculation