Abstract:The cold start-up of the PEMFC (proton exchange membrane fuel cell) stack from sub-zero temperature is considered one of the significant obstacles to its expansive commercial applications. In the cold start-up process, with the progress of hydrogen/oxygen chemical reaction, the produced water will freeze into ice, occupying the pores of the porous electrode, thus leading to a rapid deterioration of output performance and even making the cold start-up fail. In this work, a one-dimensional numerical model is adopted to study a cold start-up process of the PMEFC stack starting from −30°C. The stepwise-changed current loading mode is employed in the process. An assisted preheating method is used to explore an optimal operating condition for a successful cold start-up. The numerical results are validated by comparing the numerical result with the experimental data in reference, and they agree with the experimental data very well. The results show that the optimal heating power in the studied range is 100 W. As the initial current slope increased, the current peak value increased, but the cold start-up process failed. Also, the start-up time and ice volume fraction are highly dependent on the initial current slope. The optimal initial current slope is 0.7 A/s. Besides, a higher initial current slope will cause a significant inner ohmic resistance. The resistance of CLa (catalyst layer of the anode) is the key and primary part of the total ohmic resistance. The details of the research and the analyzed results will help design the cold start-up strategy for the PEMFC stack start-up from −30°C.

Subzero Startup of Electrochemical Power Sources Using Alternating Current

Subzero startup of polymer electrolyte fuel cell—a battle between water and thermal management at low temperatures

Numerical Studies of Cold-Start Phenomena in PEM Fuel Cells: A Review

A Review on Subzero Startup of Proton Exchange Membrane Fuel Cell

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

An efficient cold start strategy for proton exchange membrane fuel cell stacks

Study on the temperature distribution and its effect on self-start of large-area proton exchange membrane fuel cells at subzero temperatures

Alternate Hydrogen Pump Method Enables Start-Up from −30°C for Graphite-Bipolar-Plate Proton Exchange Membrane Fuel Cells

Numerical studies of cold-start phenomenon in PEM fuel cells

Ultralow Degradation Cold Start of Proton Exchange Membrane Fuel Cell with Alternating Hydrogen Pump Method

Numerical analyses of non-isothermal self-start behaviors of PEM fuel cells from subfreezing startup temperatures

Numerical Research on the Cold Start-up Strategy of a PEMFC Stack from −30°C

Cold Start of a PEMFC Using Alternating Hydrogen Pump: Part II. Optimization and Comparison with Rapid Self-Heating

Experimental Study on Cold Start Strategies of Fuel Cell Stack: Sensitivity Analysis, Optimization, and Boundaries

Experimental study on electrochemical, starting-up, and energy-saving properties of a hybrid supercapacitor as automotive starter power under low-temperature conditions

Cold Start of PEMFC Using Alternating Hydrogen Pump: Part I. Mechanistic Modeling

Frequency varying heating strategy for lithium-ion battery rapid preheating under subzero temperature considering the limitation of on-board current

A Pem Fuel Cell Model for Cold-Start Simulations

Freezing Site of Super-Cooled Water and Failure Mechanism of Cold Start of PEFC

Characteristics of Cold Start Behavior of PEM Fuel Cell with Metal Foam as Cathode Flow Field under Subfreezing Temperature

Research on the influence of electrolytes on the low-temperature start-up performance of zinc-air battery for forklifts