Abstract:Durability and start-up ability in sub-zero environment are two technical bottlenecks of vehicular polymer electrolyte membrane (PEM) fuel cell systems. With exhaust gas recirculation on the anode and cathode side, the cell voltage at low current density can be reduced, and the membrane can be humidified without external humidifier. They may be helpful to prolong the working lifetime and to promote the start-up ability. This paper presents an experimental study on a PEM fuel cell system with anodic and cathodic recirculation. The system is built up based on a 10 kW fuel cell stack, which consists of 50 cells and has an active area of 261 cm(2). A cathodic recirculation pump and a hydrogen recirculation pump are utilized on the cathode and anode side, respectively. Key parameters, e.g., stack current, stack voltage, cell voltage, air flow, relative humidity on the cathode side, oxygen concentration at the inlet and outlet of the cathode side, are measured. Results show that: 1) with a cathodic recirculation the system gets good self humidification effect, which is similar to that with an external humidifier; 2) with a cathodic recirculation and a reduction of fresh air flux, the cell voltage can be obviously reduced; 3) with an anodic recirculation the cell voltage can also be reduced due to a reduction in the hydrogen partial pressure, the relative humidity on the cathode side is a little smaller than the case with only cathode recirculation. It indicates that, for our stack the cathodic recirculation is effective to clamp cell voltage at low current density, and a self-humidification system is possible with cathodic recirculation. Further study will focus on the dynamic model and control of the dual recirculation fuel cell system. (C) 2017 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Ultralow Degradation Cold Start of Proton Exchange Membrane Fuel Cell with Alternating Hydrogen Pump Method

Cold Start of a PEMFC Using Alternating Hydrogen Pump: Part II. Optimization and Comparison with Rapid Self-Heating

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

Alternate Hydrogen Pump Method Enables Start-Up from −30°C for Graphite-Bipolar-Plate Proton Exchange Membrane Fuel Cells

Cold Start of PEMFC Using Alternating Hydrogen Pump: Part I. Mechanistic Modeling

An efficient cold start strategy for proton exchange membrane fuel cell stacks

Study on the temperature distribution and its effect on self-start of large-area proton exchange membrane fuel cells at subzero temperatures

A Pem Fuel Cell Model for Cold-Start Simulations

Numerical Studies of Cold-Start Phenomena in PEM Fuel Cells: A Review

Numerical studies of cold-start phenomenon in PEM fuel cells

Investigation on the temperature uniformity and efficiency of cold start-up for proton exchange membrane fuel cell stack based on catalytic hydrogen/oxygen method

Optimization of fast cold start strategy for PEM fuel cell stack

Experimental Study on Cold Start Strategies of Fuel Cell Stack: Sensitivity Analysis, Optimization, and Boundaries

Research on Cold Start of Proton-Exchange Membrane Fuel Cells Based on Model Predictive Control

Investigation of assisted heating cold start strategies from -40 °C for proton exchange membrane fuel cell stack

Experimental Study on Dual Recirculation of Polymer Electrolyte Membrane Fuel Cell

Study on Fast Cold Start-Up Method of Proton Exchange Membrane Fuel Cell Based on Electric Heating Technology

Energy efficient cold start of a Polymer Electrolyte Membrane Fuel Cell coupled to a thermochemical metal hydride preheater

Numerical analyses of non-isothermal self-start behaviors of PEM fuel cells from subfreezing startup temperatures

Control-Oriented Modeling of Purging Process and Cold Start of Proton-Exchange Membrane Fuel Cell

Theoretical analysis on cold start process of proton exchange membrane fuel cell with different flow fields based on the coupling of redox reaction and dynamic response of porous materials