Abstract:The cold start-up of the PEMFC (proton exchange membrane fuel cell) stack from sub-zero temperature is considered one of the significant obstacles to its expansive commercial applications. In the cold start-up process, with the progress of hydrogen/oxygen chemical reaction, the produced water will freeze into ice, occupying the pores of the porous electrode, thus leading to a rapid deterioration of output performance and even making the cold start-up fail. In this work, a one-dimensional numerical model is adopted to study a cold start-up process of the PMEFC stack starting from −30°C. The stepwise-changed current loading mode is employed in the process. An assisted preheating method is used to explore an optimal operating condition for a successful cold start-up. The numerical results are validated by comparing the numerical result with the experimental data in reference, and they agree with the experimental data very well. The results show that the optimal heating power in the studied range is 100 W. As the initial current slope increased, the current peak value increased, but the cold start-up process failed. Also, the start-up time and ice volume fraction are highly dependent on the initial current slope. The optimal initial current slope is 0.7 A/s. Besides, a higher initial current slope will cause a significant inner ohmic resistance. The resistance of CLa (catalyst layer of the anode) is the key and primary part of the total ohmic resistance. The details of the research and the analyzed results will help design the cold start-up strategy for the PEMFC stack start-up from −30°C.

Cold Start of PEMFC Using Alternating Hydrogen Pump: Part I. Mechanistic Modeling

A Pem Fuel Cell Model for Cold-Start Simulations

Cold Start of a PEMFC Using Alternating Hydrogen Pump: Part II. Optimization and Comparison with Rapid Self-Heating

Numerical Studies of Cold-Start Phenomena in PEM Fuel Cells: A Review

Numerical studies of cold-start phenomenon in PEM fuel cells

Numerical analyses of non-isothermal self-start behaviors of PEM fuel cells from subfreezing startup temperatures

Freeze Start of Proton Exchange Membrane Fuel Cell Systems with Closed-Loop Purging and Improved Voltage Consistency

Modeling of Fuel Cell Cold Start and Dimension Reduction Simplification Method

Ultralow Degradation Cold Start of Proton Exchange Membrane Fuel Cell with Alternating Hydrogen Pump Method

Thermal Stability Analysis of Cold Start Processes in PEM Fuel Cells

Numerical Research on the Cold Start-up Strategy of a PEMFC Stack from −30°C

A Comparative Study: the Effect of Current Loading Modes on the Cold Start-Up Process of PEMFC Stack

Transient Behavior of PEM Fuel Cells

A single-phase, non-isothermal model for PEM fuel cells

Modeling Transport of Membrane Water in PEMFC and Energy Loss Analysis at −20 °C Based on Mathematical Boundedness

Optimization of fast cold start strategy for PEM fuel cell stack

Research on Cold Start of Proton-Exchange Membrane Fuel Cells Based on Model Predictive Control

Alternate Hydrogen Pump Method Enables Start-Up from −30°C for Graphite-Bipolar-Plate Proton Exchange Membrane Fuel Cells

Cold Start Mode Classification Based on the Water State for Proton Exchange Membrane Fuel Cells

Impact of Schroeder's Paradox on Cold Start-Up Failure of Proton Exchange Membrane Fuel Cells: Three-dimension Simulation Based on OpenFOAM

Investigation of assisted heating cold start strategies from -40 °C for proton exchange membrane fuel cell stack