Abstract:Damage to mechanical components caused by contaminant ingress is a common failure. In response to this issue, this study introduces a synergistic abrasion reduction method based on the combined application of ceramic materials and surface texturing. Using cylindrical thrust roller bearings as an illustration, circular textures were applied to the raceways, and a small number of steel rollers were substituted with ceramic ones. Moreover, alumina was introduced into the lubricant as a contaminant. The frictional and dynamic performance of the "ceramic-textured surface" combination under lubricant contamination conditions was explored and compared with corresponding single abrasion reduction techniques. The synergistic abrasion reduction mechanism of the "ceramic-textured surface" combination was also examined. The findings reveal that under lubricant contamination conditions, the synergistic abrasion reduction method surpasses individual abrasion reduction methods and demonstrates a certain degree of complementarity. Compared with traditional all-steel bearings, textured bearings with four ceramic rollers have reduced the average frictional force by approximately 56.82%, and the mass loss of the shaft washer and seat washer has been reduced by approximately 81.01% and 80.86%, respectively. Rolling elements treated with the synergistic abrasion reduction method exhibit enhanced resistance to abrasive particle wear. This improvement is attributed to the collaborative effects of various mechanisms, including crushing and refinement, capture and storage, grinding and finishing, as well as self-healing and smoothing.

Failure Analysis of SKF-typed Rolling Bearing

Fracture Failure Analysis of Bearing Outer Race in Motors of Blower

Failure Analysis on Excess Wear of Rolling Bearing of Motors for Supply Blower

Failure Analysis of Fatigue Fracture on the Outer Ring of a Cylindrical Roller Bearing in an Air Blower Motor

Fatigue Failure Analysis of a Grease-Lubricated Roller Bearing from an Electric Motor

Failure Analysis of a Cylindrical Roller Bearing Caused by Excessive Tightening Axial Force

Analysis of Bearing Failures in a Typical High-Power Marine Gearbox

Failure analysis for outer ring cracking of GCr15 rolling bearing

Failure analysis of an aero-engine inter-shaft bearing due to clearance between the outer ring and its housing

Experimental Study on the Skidding Damage of a Cylindrical Roller Bearing

Failure analysis of journal bearing used in turboset of a power plant

A fatigue failure investigation and improvement of a high-speed cylindrical roller bearing in a turbofan engine

Failure Analysis on Abnormal Wear of Roller Bearings in Gearbox for Wind Turbine

Analysis of the tribological and dynamic performance of textured bearings under contaminated conditions

Diagnosis and root cause analysis of bearing failure using vibration analysis techniques

A surface study of failed planetary wind turbine gearbox Bearings to investigate the causes of the Bearing premature failure issue

Analysis and Evaluation of the Synergistic Effect of Ceramic Materials and Surface Texture on Anti-Abrasive Particle Wear under Rolling Conditions

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Structure–performance evolution mechanism of the wear failure process of coated spherical plain bearings

Dynamic, Thermal, and Vibrational Analysis of Ball Bearings with Over-Skidding Behavior

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings