Abstract:Combustors with fuel-spray atomizers are particularly susceptible to a low-frequency oscillation at idle and subidle conditions. For aeroengine combustors, the frequency of this oscillation is typically in the range 50–120 Hz and is commonly called “rumble.” The mechanism involves interaction between the plenum around the burner and the combustion chamber. Pressure variations in the plenum or the combustor alter the inlet air and fuel spray characteristics, thereby changing the rate of combustion. This in turn leads to local “hot spots” which generate pressure oscillations as they convect through the downstream nozzle. In order to eliminate the combustion oscillations, it is essential to determine which fuel atomizers are particularly likely to lead to instability by quantifying their sensitivity to flow perturbations. This can be done by identifying the system through understanding the transfer function, which represents the relationship between the unsteadiness of combustion and the inlet fuel and air. In the present work, various types of signals are applied to produce a small change in the inlet fuel and air flow rates, the response in the rate of heat release caused downstream was calculated and stored for subsequent analysis. Afterwards, the system transfer function is calculated by determining the coefficients of an IIR filter (Infinite Impulse Response) for which the output signal is the downstream heat release rate and the input signal is the inlet flow rate. The required transfer function then follows from the Fourier transform of this relationship. The resulting transfer functions are compared with those obtained by the forced harmonic oscillations at a fixed given frequency. Suitably chosen input signals accurately recover the results for harmonic forcing at a single frequency, but also give detailed information about the combustor response over a wide frequency range. There are two distinct forms to the low-frequency quasisteady response. In the primary zone, the rate of combustion is influenced by the turbulence and is enhanced when the inlet air velocity is large. Near the edge of combustion zone, the rate of combustion depends on the mixture fraction and is high when the mixture fraction is close to the stoichiometric value. This generates ‘hot spots’ which convect into the dilution zone. At higher frequencies, the combustion lags this quasi-steady response through simple lag-laws and the relevant time delays have been identified.

Effects of Baffles on Self-Triggered High Frequency Pressure Oscillations in a Thrust Chamber

The Effect of Swirling Injector Geometry on the Flow Dynamics of Precessing Vortex Core

Experimental Investigation on High Frequency Perturbation to Combustion Instability by Low Frequency Actuator in a Backward-facing Step Combustor

Analysis of Combustion Characteristics in the Region with Violent Pressure Oscillations in Thruster Chamber

Analysis of combustion instability via constant volume combustion in a LOX/RP-1 bipropellant liquid rocket engine

Exploring Vortex–Flame Interactions and Combustion Dynamics in Bluff Body-Stabilized Diffusion Flames: Effects of Incoming Flow Velocity and Oxygen Content

Numerical evaluation of acoustic characteristics and their damping of a thrust chamber using a constant-volume bomb model

Effect of baffle injectors on the first-order tangential acoustic mode in a cylindrical combustor

The acoustic transfer impedance of baffled injectors in three-dimensional combustion chambers

Transfer Function Calculations for Aeroengine Combustion Oscillations

Flame stabilization of liquid oxygen/kerosene bi-swirl injector at elevated pressure

Investigation on Acoustic Properties of Thruster Chamber with Coaxial Injectors and Plenum Chamber

The effect of inlet boundaries on combustion instability in a pressure-elevated combustor

Experimental investigation of self-excited combustion instabilities in a small Earth storable bipropellant rocket combustor

The damping and locking of self-excited azimuthal modes by baffles installed in the plenum of an annular combustor

Impact of shear-coaxial injector hydrodynamics on high-frequency combustion instabilities in a representative cryogenic rocket engine

Experimental Investigation on Pressure and Flame Surface Oscillation in a Dual-Cavity Scramjet Combustor

Experimental Study of the Effect of Outlet Boundary on Combustion Instabilities in Premixed Swirling Flames

Influence of Thermal Inhibitor Position and Temperature on Vortex-Shedding-driven Pressure Oscillations

A 2D Low-Order Thermoacoustic Network Model of Annular Combustor with Baffles in the Plenum

Effects of spray angle on the pressure oscillations in the combustion chamber of LOX/RP-1 liquid rocket engine