Abstract:In the present paper, adhesive test, morphology observation, classified counting and deformation index calculation of the platelets on seven DLC samples made by different processes were carried out after XPS analysis, respectively. Then the effects of carbon phase components on amounts and deformation index of the platelets adhered to the samples were investigated by using the analysis of T-type correlation degree in the grey system theory. It has been shown from results that the amounts and the deformation index of the platelets adhered to the DLC samples made by plasma source ion implantation-ion beam enhanced deposition (PSII-IBED) are obviously less than those of DLC samples made by plasma CVD. The correlation degrees (negative) between the DLC carbon phase and the amounts as well as the deformation index of platelets are much more than those of the other four carbon phase components; besides, larger correlation degrees (positive) only appear between the deformation index of platelets and the C-H carbon phase or C-O carbon phase. It has been indicated that: (1) the effect of DLC carbon phase on platelets adhesion is much greater than that of the other four carbon phase components, the key to improvement in the hemocompatibility of DLC is to increase the DLC carbon phase content; (2) it is necessary to restrain the form or decrease the C-H carbon phase content and C-O carbon phase content so as to control their promotive action on deformation of the platelets adhered to the surface of DLC; (3) using PSII-IBED process to prepare DLC is helpful to improving the hemocompatibility of DLC. These conclusions are essential for designing and improving the deposition process of DLC.

Synthesized by Plasma Immersion Ion Implantation-Deposition

Blood compatibility and sp3/sp2 contents of diamond-like carbon (DLC) synthesized by plasma immersion ion implantation-deposition

Deposition of nano-diamond-like carbon films by an atmospheric pressure plasma gun and diagnostic by optical emission spectrum on the process

DLC films fabricated by plasma immersion ion implantation and deposition on the NiTi alloys for improving their corrosion resistance and biocompatibility

DLC Film Fabrication on the Inner Surface of a Cylinder by Carbon Ion Implantation

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Diamond-like carbon films synthesized on bearing steel surface by plasma immersion ion implantation and deposition

Structure and Tribology Properties of Diamond-Like Carbon Films Prepared by Microwave Electron Cyclotron Resonance Plasma Source Ion Implantation

Surface Characterization and Blood Compatibility of Diamond-Like Carbon (DLC) Films on the NiTi Alloys

DLC Film Fabricated by a Composite Technique of Unbalanced Magnetron Sputtering and PIII.

[Effects of Carbon Phase Components on Platelets Adhesion for Diamond Like Carbon (DLC)].

Structures and tribological properties of diamond-like carbon films prepared by plasma-based ion implantation on Si

Structure and Topographies of Diamond-Like Carbon Films Produced on Tungsten Pre-Implanted Stainless Steel Substrate by Plasma Immersion Ion Implantation and Deposition

Nanomechanical and Electrochemical Properties of Diamond-Like Carbon (DLC) Films Deposited by Plasma Enhanced Chemical Vapor Deposition (PECVD) Technique

Study of Diamond-like Carbon Synthesized by Metal Plasma Immersion Ion Implantation and Deposition

Preparation of Diamond-like Carbon Films by Plasma Source Ion Implantation

Tribological Performance of Ultrathin Diamond-Like Carbon Films Prepared by Plasma-Based Ion Implantation

Deposition of DLC coating on biomedical TiNi alloys by plasma based ion implantation to improve surface properties

Characteristics and Surface Energy of Silicon-Doped Diamond-Like Carbon Films Fabricated by Plasma Immersion Ion Implantation and Deposition

Diamond-like Carbon (DLC) Films Deposited on Copper Substrate Through Preparation of Intermediate Layers

Structure and Properties of Diamond-Like Carbon Films Prepared by High-Intensity Pulsed-Ion-beam Ablation Deposition