Abstract:Due to its extreme service conditions, low-temperature pressure piping often needs post-welding stress measurement and control. Aiming at the phenomenon of local stress concentration in welded 316L pipes, this study used ultrasound to regulate the stress in the welded area at different times during and after the multi-layer welding of the pipeline butt joint for different time lengths. Mechanical properties such as tensile strength and hardness were tested for each comparison group, and the microcrystalline phases of the weld and its surrounding microstructure were analyzed. The transverse and longitudinal surface residual stresses of each comparison group were measured. The influence of high-energy ultrasound on the surface temperature field during and after welding was analyzed. The experimental results show that ultrasonic wave regulation can speed up heat exchange and radiation in the weld zone (WZ), refine the grains in the WZ, heat-affected zone (HAZ) and fusion zone (FZ) to some extent and reduce and homogenize residual stress to a certain degree. In the 120 mm area of the weld center, the residual stress measured after the mid-welding regulation was smaller than that of any other comparison group. This regulation result was the best, followed by that of hot regulation and finally that of offline regulation. The tensile strengths obtained by the mid-welding regulation and post-welding hot regulation of this group were the best, increasing by 17.2% and 24.3%, respectively, compared with the untreated groups.

RESEARCH ON THE FACTORS AFFECTING THE STABILITY OF THE SENSITIVITY OF AUTOMATIC ALARMING ULTRASONIC IMMERSION TESTING OF SMALL-DIAMETER THIN-WALL PIPES BY TRANSVERSE WAVES

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Research on the Integrated Ultrasound and Eddy Automatic Inspection System of Seamless Steel Pipe

Analysis and Experimental Study on the Measurement of Pipe Wall Thinning by Perturbation Method

Research of Automatic Ultrasonic Test System for Round Bar Flaw

Investigation of pipe thickness monitoring using the shear wave EMAT technology with high lift-off distance

Application of Microwaves for Nondestructive and High-Efficiency Detection of Wall Thinning Locations in a Long-Distance Metal Pipe

Research on reducing electromagnetic disturbance of laboratory-made ultrasonic detection devices

1509 Microwave Measurement and Evaluation of Wall Thinning in Metal Pipes

Microwave Measurement and Quantitative Evaluation of Wall Thinning in Metal Pipes

G0310501 A Method for Quantitative Evaluation of Pipe Wall Thinning Using Microwaves

A high-efficiency nondestructive method for remote detection and quantitative evaluation of pipe wall thinning using microwaves

Research on Transmission Performance of a Surface Acoustic Wave Sensing System Used in Manufacturing Environment Monitoring

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Optimizing the Frequency Range of Microwaves for High-Resolution Evaluation of Wall Thinning Locations in a Long-Distance Metal Pipe

Advancement in understanding ultrasonic wave propagation in metallic pipes by simulation and experimental validation

A Study on the Ultrasonic Regulation of the Welding Performance and Residual Stress of 316L Stainless Steel Pipes

Investigation on the influence of wall thickness on the reception signal in a PFA-made ultrasonic flow sensor

Research on settlement stress detection and control measures for in-service pipelines in valve chamber

Laser ultrasonic system for metal pipe wall thickness measurement: Differential signal processing and geometric compensation calculation model

The Experimental Investigation of Ultrasonic Testing Sensitivity for Internal Surface Radial Defects in Cylindrical Item with Thick Wall