Abstract:The structural integrity assessment of thermoplastic pipes has become an interesting area of research due to its elevated usage in the liquid/gas transportation industry. Ultrasonic guided wave testing has gained higher attention from industry for the inspection of elongated structures due to the reduced inspection time and cost associated with conventional non-destructive testing techniques, e.g., ultrasonic testing, radiography, and visual inspection. Current research addresses the inspection of thermoplastic pipes using ultrasonic guided waves as a low cost and permanently installed structural health-monitoring tool. Laboratory and numerical investigations were conducted to study the potential of using ultrasonic guided waves to assess the structural health of thermoplastic pipe structures in order to define optimum frequency range for inspection, array design, and length of inspection. In order to achieve a better surface contact, flexible Macro-Fiber Composite transducers were used in this investigation, and the Teletest® Focus+ system was used as the pulser/receiver. Optimum frequency range of inspection was at 15−25 kHz due to the level of attenuation at higher frequencies and the larger dead zone at lower frequencies due to the pulse length. A minimum of 14 transducers around the circumference of a 3 inch pipe were required to suppress higher order flexural modes at 16 kHz. According to the studied condition, 1.84 m of inspection coverage could be achieved at a single direction for pulse-echo, which could be improved by using a higher number of transducers for excitation and using pitch-catch configuration.

Advancement in understanding ultrasonic wave propagation in metallic pipes by simulation and experimental validation

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Application of Microwaves for Nondestructive and High-Efficiency Detection of Wall Thinning Locations in a Long-Distance Metal Pipe

1509 Microwave Measurement and Evaluation of Wall Thinning in Metal Pipes

Microwave Measurement and Quantitative Evaluation of Wall Thinning in Metal Pipes

A high-efficiency nondestructive method for remote detection and quantitative evaluation of pipe wall thinning using microwaves

Optimizing the Frequency Range of Microwaves for High-Resolution Evaluation of Wall Thinning Locations in a Long-Distance Metal Pipe

Pipeline thickness measurement for in-line inspection using wholly stepped electromagnetic acoustic transducers

Deconvolution Imaging of Weak Reflective Pipe Defects Using Guided-Wave Signals Captured by a Scanning Receiver

Analysis and Experimental Study on the Measurement of Pipe Wall Thinning by Perturbation Method

Laser ultrasonic system for metal pipe wall thickness measurement: Differential signal processing and geometric compensation calculation model

Detection, Localisation and Assessment of Defects in Pipes Using Guided Wave Techniques: A Review

G0310501 A Method for Quantitative Evaluation of Pipe Wall Thinning Using Microwaves

Development of a 16-Channel Broadband Piezoelectric Micro Ultrasonic Transducer Array Probe for Pipeline Butt-Welded Defect Detection

Application of Ultrasonic Guided Waves for Inspection of High Density Polyethylene Pipe Systems

Study on the Relationship Between Thickness Measurement and Strength Defect of Buried Pipeline

Wall thickness measurement and defect detection in ductile iron pipe structures using laser ultrasonic and improved variational mode decomposition

Quantitative evaluation of pipe wall thinning defect sizes using microwave NDT

Application Research of Ultrasonic-Guided Wave Technology in Pipeline Corrosion Defect Detection: A Review

Simulations and experimentation of ultrasonic wave propagation and flaw characterisation for underwater concrete structures

SIMULATION OF DEFECTS IN ULTRASONIC TESTING OF WELDED JOINTS