Abstract:Because they have the potential for ultra low NOx emissions and high efficiency, Homogeneous Charge Compression Ignition (HCCI) engines have the potential to develop a significant niche. However, a narrow operating range, (bracketed by severe knock and misfire problems), presents a formidable obstacle to developing usable HCCI combustion systems. HCCI combustion is influenced by a complex array of operating variables including fuel octane quality, intake preheating temperature, compression ratio, equivalence ratio, exhaust gas recirculation and engine component temperature. These variables affect the two critical combustion parameters: ignition timing and combustion duration. If these two parameters can be controlled by appropriate settings of the operating variables, a good HCCI combustion scheme could be achieved. Therefore, the theoretical prediction of these two combustion parameters as a function of the key operating variables is necessary for development of HCCI combustion. This paper describes a stand-alone, single-zone and multi-zone combustion model which have been developed for the specific purpose of investigating HCCI combustion control. In the multi-zone model, temperature and composition in each zone were adjusted in order to study the effect of in-homogeneity which is critical to understanding ignition timing and combustion duration in real HCCI engines. The models simulated HCCI combustion using two fuels: hydrogen, (11 species, 23 reactions- from CHEMKIN library), and natural gas, (53 species, 325 reactions- from GRI mech). The capabilities of the two models to predict ignition timing, combustion duration and peak pressure were verified against experimental and simulation results of Fiveland et al [2, 11]. The models were then used to study the effect of different in-homogeneity levels of equivalence ratio, intake temperature and residual fraction. The single zone model could only predict ignition timing while the multi-zone model shows the capability to mimic realistic HCCI combustion phenomena. The study showed that some degree of in-homogeneity is critical to predicting performance of the homogeneous charge compression ignition engine. Further, stratification of equivalence ratio was relatively ineffective at changing combustion while stratification of mixture temperature was very effective. Stratification of the residual fraction proved to be the most promising method of controlling combustion parameters and the mechanism was primarily thermal.

Numerical Simulation on HCCI Combustion of Reformed Methanol Gas Engine

Numerical Simulation Of Re-Entrant Bowl Effects On Natural-Gas Spark-Ignition Operation

Numerical Simulation of HCNG Engine on GT-Power

Computational Analysis of Ammonia-Hydrogen Blends in Homogeneous Charge Compression Ignition Mode of Engine Operation

Numerical Simulation of HCCI Engine with Multi-Stage Gasoline Direct Injection Using 3D-CFD with Detailed Chemistry

Numerical Modeling of Diesel Engine Combustion and Emissions Under HCCI-Like Conditions With High EGR Levels

Comparison of Single-zone and Multi-zone Combustion Model for HCCI Engine

Numerical study on the combustion and emission characteristics of a methanol/diesel reactivity controlled compression ignition (RCCI) engine

Modeling of HCCI combustion: From 0D to 3D

A Stand-Alone Multi-Zone Model for Combustion in HCCI Engines

Multi-dimensional Simulation Study of an HCNG Engine

Numerical Study of Hydrogen Addition to DME/CH4 Dual Fuel RCCI Engine

Study of HCCI Combustion Characteristics with High RON Fuel

Numerical Study of Charge Stratification on Load Extension of Gasoline HCCI

Effect of Hydrogen Addition on Methane Hcci Engine Ignition Timing and Emissions Using A Multi-Zone Model

Experiment and Chemical Kinetics Analysis of Active Atmosphere with Different Fuels in HCCI Combustion

A computational study of direct injection gasoline HCCI engine with secondary injection

Use of Catalytic Reforming to Aid Natural Gas HCCI Combustion in Engines: Experimental and Modelling Results of Open-Loop Fuel Reforming

Numerical Simulation of Gasoline Stratified Charge Compression Ignition Using 3D-CFD Coupled with Detailed Chemistry

Multi-objective optimization of a compression ignition engine using on-board methanol reforming

Simulation and Analysis of Hydrogen-fueled Engine Combustion