Abstract:Space nuclear power systems should be strictly limited in mass and size. Lack of detailed designs, mass estimation in the general design phase usually relies on simple and empirical models that leave too much design margin from the limits. Accurate mass estimation of space nuclear power systems is key to minimize the design margin and maximize the system performance in the general design phase. In this paper, new mass estimation models are proposed for the main components of space nuclear power systems, including nuclear reactor, shield, turbine, compressor, heat exchanger, and thermal radiator. The mass estimation models are more accurate by incorporating principles of nuclear physics, thermal hydraulics, and structural mechanics to the component designs. Combined with thermodynamic models and genetic algorithm, the MEGREZ code is developed to optimize the system performance by setting efficiency and mass as dual objectives. The code verification results indicate that the deviations between and the Jupiter Icy Moons Orbiter project parameters and the code calculated values are only 0.4% for system efficiency and 2.1% for system mass. The optimization for the Jupiter Icy Moons Orbiter project shows that the optimal molecular weight of helium-xenon mixture is the minimum value for single-stage turbomachinery limits. Additionally, the impacts of potential technological degradation, such as increased heat exchanger thermal resistances, higher frictional factors, and decreased turbomachinery efficiency, on system performances are discussed. The results show that turbomachinery efficiency presents the strongest influence on the system-specific mass; a 0.04 reduction in the polytropic efficiency of the compressor or turbine results in more than a 10% increase in system-specific mass.

Mass Optimization of Thermo Hydraulic Network of Manned Spacecraft Environment Control and Life Support System

Optimization of Thermal Network for Spacecraft Thermal Control and Environment Control and Life Support System

Ptimization of the Thermal Network in Parallel Connection of Manned Spacecraft

The Lightweight Design for the Parallel Loops in the Thermal Control System of Manned Spacecraft

Conditional Extremum Optimization Analyses and Calculation of the Active Thermal Control System Mass of Manned Spacecraft

Minimization of mass for heat exchanger networks in spacecrafts based on the entransy dissipation theory

Global Mass Optimization of Spacecraft Thermal Control Loop

Characteristics and Optimation of Heat Pipe Radiator for Space Nuclear Propulsion Spacecraft

Design and Optimization for Fluid Loops of Active Thermal Control System in Manned Spacecraft

Optimization Analysis Of Thermal Network Layout

Performance analysis and optimization of heat pipe-based radiator for space nuclear power system

Thermal scale modeling of radiation-convection system in micro-gravity environment

Optimization of the aero-engine thermal management system with intermediate cycle based on heat current method

Performance Analysis and Optimization of Heat Pipe-Based Radiator for Space Fission Power System Thermal Management

Application of Entransy to Optimization Design of Parallel Thermal Network of Thermal Control System in Spacecraft

Optimization of Manifold Microchannel Heat Sink Based on Design of Experiment Method

Analysis of Mass Minimization of Thermoelectric Integrated Membrane Evaporation Subsystem in Waste Water Processing

Efficiency and Mass Optimization for Space Nuclear Power Systems with Closed Brayton Cycle Loops

Research on flow distribution optimization method of fluid loop system based on generalized Lagrange multiplier method

Groundbased Simulation of Flow,heat and Mass Transfer in Microgravity Environment

Energy Allocation Optimization of the Gas-Cooled Space Nuclear Reactor