Abstract:An experimental simulation study on the transition from pressurized to boiling operation of a low-temperature, natural circulation nuclear heating reactor (5 MW) developed by INET of Tsinghua University is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instabilities, namely geysering, flashing instability and low-steam quality density wave instability on the transition from pressurized to boiling operation is described. The mechanism of flashing instability, which has never been studied well on this field, is especially interpreted. It is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: (1) increasing of initial pressure by means of a noncondensable gas (N2), which is a very effective method to eliminate geysering and flashing instability at lower pressure. (2) start-up of the reactor at this pressurized condition with a constant heat flux under the limited value of 9 = 0.15 MW ?m-2, which controls the exit temperature of the heated section below the one of net vapor generation, the low steam quality density wave oscillation can be avoided. (3) transition to a lower pressure, boiling operation. The method of transition with low-heat flux and low-inlet subcooling is proposed: at pressurized operation condition, by reducing the heat flux to its lowest level, releasing the noncondensable gas and increasing the heat flux gradually (dq/dt3 kW ?m- 2 ?min-1l) , during which the low-steam quality density wave oscillation can be be prevented from occurring, then the boiling operation condition can be achieved through adjusting the heat flux and inlet subcooling to their designed value. A stable transition from pressurized to boiling operation of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.

Simulation Criteria to Study on Gravityboron Injection System of NHR200

Experimental research on the gravity-driven boron injection system for a 200 MW nuclear heating reactor

Experimental investigation on the pressure response characteristic of the gravity driven boron injection system

Experimental Investigation on the Pressure Response Characteristic of the Gravity Driven Boron Injection System / Experimentelle Untersuchung Zur Druckantwortcharakteristik Eines Gravitationsgetriebenen Boreinspeisesystems

Experimental Research on the Pressure Response of Gravity Boron Injection System

Experimental Investigation on Flow Behavior During Start-up of a Heating Reactor

Experimental Simulation Study On Start-Up Of The 5 Mw Nuclear Heating Reactor

Experimental simulation on transit process of the 5MW nuclear reactor

Numerical Simulation of the Transient Flow Characteristics and Thermal Stratification Phenomena in the Passive Residual Heat Removal System of NHR-200-II

Analysis of Transient Characteristics and Design Improvement of the Passive Residual Heat Removal System of NHR-200-II

Dynamic simulation of a space lithium-cooled reactor system coupled with a He–Xe closed Brayton cycle

Dynamic Modeling of the NSSS Based on NHR200-II Nuclear Heating Reactor

Numerical and Experimental Investigations of the Static Characteristics of A Natural Circulation System at Nuclear Heating Reactor Conditions

Dynamic response simulation for high temperature gas-cooled reactor with indirect closed brayton cycle

Thermalhydraulic Investigation Using a Test Facility Simulating 200 MW Integral Heating Reactor

Simulation experiment on fuel assembly flow resistance behavior of NHR-200

Simulation of Volume Compensator in 200 MW Low-Temperature Heating Reactor

Numerical Simulation of Flow Distribution in the Lower Plenum of NHR200-II

Scaling analysis of thermal-hydraulics for steam generator passive heat removal system

Experimental simulation study on hydraulic behavior of the main heat exchanger of daqing 200 mw nuclear heating reactor

Simulation Study of Nuclear Heating Reactor Control Method in Slight Boiling Operation Mode