Abstract:A reactor is an important piece of equipment used for reactive power compensation in power system and has a significant impact on the safe operation of power system. Thermal behavior is one of the main causes of reactor failures. For an accurate analysis of the thermal behavior of reactors, electromagnetic–thermal–fluid multi-physics coupling modeling is chosen. However, there is a huge difference in size between the overall structure of the reactor and its insulating material, which makes it difficult to perform mesh generation, resulting in dense mesh and significantly increased solution degrees of freedom, thus making the solution of the reactor’s multi-physics field model very time-consuming. To address this, this paper proposes a simplified processing method to accelerate the solution calculation of the reactor’s multi-physics model. This method calculates the equivalent turns of each encapsulate with parallel coils in the reactor, simplifying the encapsulate into a single-layer coil, thereby greatly reducing the division and solution degrees of freedom of the multi-physics model, and thus accelerating the simulation calculation. Taking a BKDCKL-20000/35 dry-type air-core shunt reactor as an example, the outer diameter of the coil is nearly 12,000 times bigger than the coil insulation, which is a huge size difference. Both refined models and simplified models are established. Compared to the simulation results of the detailed model, the simplified model demonstrates good accuracy; the maximum relative error of temperature is just 2.19%. Meanwhile, the computational time of the simplified model is reduced by 35.7%, which shows promising effectiveness and significant potential for applying the optimization design and operation prediction of dry-type air-core shunt reactors for enhanced thermal performance.

A Conservation-Equation-based Method to Diagnose Reactor Components Faults

Application Of Grey Theory To Fault Prediction Of Chemical Equipment System

Real-time simulations to enhance distributed on-line monitoring and fault detection in Pressurized Water Reactors

A Simulation Method for Nuclear Power Plant with High-Temperature Gas-Cooled Reactor

Identification-based Sensor and Actuator Fault Diagnosis for Industrial Control Systems and Its Application to HTR-PM

Simultaneous Approach for Simulation of A High-Temperature Gas-Cooled Reactor

Simulation and Analysis of Reactor Fault Distributed Current Based on the Combination of Field and Circuit Models

A Fault Analysis of 750kV Shunt Reactor and Repair Program

Model‐based fault diagnosis for safety‐critical chemical reactors: An experimental study

Data-Model Fusion-Driven Method for Fault Quantitative Diagnosis of Heat Exchanger

Modeling and Simulation of BWR Mechanism Based on RELAP5

Progress in Thermohydraulic Analysis of Accident Scenarios of A Water-Cooled Fusion Demo Reactor

Improved methods of online monitoring and prediction in condensate and feed water system of nuclear power plant

Proposal and Validation of a Diagnosis Method of Fuel Failures in Pressurized Water Reactor Nuclear Power Plants

Card fault diagnosis of the pressurized water reactor off-heap nuclear measurement system based on expert experience and convolutional neural network

Reliability Analysis of Nuclear Power Plant Electrical System Considering Common Cause Failure Based on GO-FLOW

Application of Improved Quasi-Static Method to High Temperature Gas Cooled Reactor Simulator

Mathematical modeling of a steam generator for sensor fault detection

A Detection Method for Slight Inter-Turn Short-Circuit Fault in Dry-Type Air-Core Shunt Reactors

Dynamic Stability Analysis of High-Power DC Reactor for ITER Poloidal Field Converter

Thermal Simulation and Analysis of Dry-Type Air-Core Reactors Based on Multi-Physics Coupling