Abstract:In this paper, the large signal operation of the ring oscillator based injection locked frequency divider is analyzed considering the trade-offs among the operating frequency, locking range and power consumption. A large signal model is used to reveal several key findings such as voltage-limited locking ranges and asymmetry between the upper and lower locking bands. They are applied to the optimize the dividers maintaining a good balance among design considerations. Several prototypes, including the divide-by-2 with 3 and 5 stages of inverters, divide-by-3 and divide-by-5, are implemented in a standard 0.18 µm CMOS technology to verify the operation under a large injected signal. As an extension, dual-modulus prescalers are further designed by the integration of switches for different ways of signal mixing. Measurements results show the proposed divide-by-2/3 unit and a divide-by-8/9 with this unit are able to work up to 8 GHz and 4.0 GHz with maximum power consumption of 0.7 mW and 1.5 mW respectively.

A 1.5 Mw 26.2&#x2013;32.2 GHz Divide-by-4 Injection-Locked Frequency Divider in 130 Nm CMOS Process

A Dual-Mode Mm-Wave Injection-Locked Frequency Divider with Greater Than 18% Locking Range in 65nm CMOS

A 3 Mw 54.6 GHz Divide-by-3 Injection Locked Frequency Divider with Resistive Harmonic Enhancement

19.1 GHz 18 Mw Divide-by-3 Heterodyne Injection Locking Frequency Divider in 0.18 Μm CMOS Technology

A Low Power V-Band CMOS Frequency Divider with Wide Locking Range and Accurate Quadrature Output Phases.

A Wide Locking Range and Low Power V-band Frequency Divider in 90nm CMOS

6.2 GHz 0.5 Mw Two‐dimensional Oscillator Array‐based Injection‐locked Frequency Divider in 0.18 Μm CMOS

Optimization of Injection Locked Frequency Divider with Tunable Active Inductor

Gigahertz range injection locked frequency dividers with band-width enhancement and supply rejection

A 30-Ghz to 39-Ghz Mm-Wave Low-Power Injection-Locked Frequency Divider in 65nm CMOS.

A 150ghz Injection-Locked Frequency Divider with 19.8% Locking Range Based on Adjustable Inductor Tuning Method in 65-Nm CMOS

Sub-mW Multi-Ghz CMOS Dual-Modulus Prescalers Based on Programmable Injection-Locked Frequency Dividers

A 1.2 V 10 GHz Injection Locked Frequency Divider for High Frequency and Low Power System

Design and optimization of the ring oscillator based injection locked frequency dividers.

A 60ghz Wideband Injection-Locked Frequency Divider with Adaptive-Phase-enhancing Technique

A Divide-by-4 and Divide-by-6 Injection-locked Frequency Divider using Even-Harmonic Direct Injection Method for V-band Applications

A Cmos Frequency Divider for 2.4/5ghz Wlan Applications with A Simplified Structure

A 60.8–67GHz and 6.3mW injection-locked frequency divider with switching-inductor loaded transformer in 65nm CMOS

A Reliability-Oriented Startup Analysis of Injection-Locked Frequency Divider Based on Broken Symmetry Theory

A 13.2% Locking-Range Divide-by-6, 3.1mw, ILFD Using Even-Harmonic-enhanced Direct Injection Technique for Millimeter-Wave PLLs

Odd Phase Switching Prescaler Based on Injection Locked Frequency Divider

A 1.5 Mw 26.2&amp;#x2013;32.2 GHz Divide-by-4 Injection-Locked Frequency Divider in 130 Nm CMOS Process