Abstract:In this paper, the large signal operation of the ring oscillator based injection locked frequency divider is analyzed considering the trade-offs among the operating frequency, locking range and power consumption. A large signal model is used to reveal several key findings such as voltage-limited locking ranges and asymmetry between the upper and lower locking bands. They are applied to the optimize the dividers maintaining a good balance among design considerations. Several prototypes, including the divide-by-2 with 3 and 5 stages of inverters, divide-by-3 and divide-by-5, are implemented in a standard 0.18 µm CMOS technology to verify the operation under a large injected signal. As an extension, dual-modulus prescalers are further designed by the integration of switches for different ways of signal mixing. Measurements results show the proposed divide-by-2/3 unit and a divide-by-8/9 with this unit are able to work up to 8 GHz and 4.0 GHz with maximum power consumption of 0.7 mW and 1.5 mW respectively.

A Divide-by-4 and Divide-by-6 Injection-locked Frequency Divider using Even-Harmonic Direct Injection Method for V-band Applications

A 3 Mw 54.6 GHz Divide-by-3 Injection Locked Frequency Divider with Resistive Harmonic Enhancement

A Dual-Mode Mm-Wave Injection-Locked Frequency Divider with Greater Than 18% Locking Range in 65nm CMOS

6.2 GHz 0.5 Mw Two‐dimensional Oscillator Array‐based Injection‐locked Frequency Divider in 0.18 Μm CMOS

A Wide Locking Range and Low Power V-band Frequency Divider in 90nm CMOS

19.1 GHz 18 Mw Divide-by-3 Heterodyne Injection Locking Frequency Divider in 0.18 Μm CMOS Technology

A Low Power V-Band CMOS Frequency Divider with Wide Locking Range and Accurate Quadrature Output Phases.

A Dual-Step-Mixing ILFD Using a Direct Injection Technique for High- Order Division Ratios in 60ghz Applications

Design and optimization of the ring oscillator based injection locked frequency dividers.

Optimization of Injection Locked Frequency Divider with Tunable Active Inductor

A 13.2% Locking-Range Divide-by-6, 3.1mw, ILFD Using Even-Harmonic-enhanced Direct Injection Technique for Millimeter-Wave PLLs

A 1.5 Mw 26.2&#x2013;32.2 GHz Divide-by-4 Injection-Locked Frequency Divider in 130 Nm CMOS Process

Gigahertz range injection locked frequency dividers with band-width enhancement and supply rejection

Odd Phase Switching Prescaler Based on Injection Locked Frequency Divider

200Ghz CMOS Prescalers with Extended Dividing Range Via Time-Interleaved Dual Injection Locking

A 150ghz Injection-Locked Frequency Divider with 19.8% Locking Range Based on Adjustable Inductor Tuning Method in 65-Nm CMOS

A U-Band Direct Injection-Locked Frequency Divider with Wide Input Locking Range and Low Power

Sub-mW Multi-Ghz CMOS Dual-Modulus Prescalers Based on Programmable Injection-Locked Frequency Dividers

A 60ghz Wideband Injection-Locked Frequency Divider with Adaptive-Phase-enhancing Technique

A Reliability-Oriented Startup Analysis of Injection-Locked Frequency Divider Based on Broken Symmetry Theory

A wide locking range injection‐locked frequency divider with an auto‐adjusted injection bias