Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

A Sigma Converter for High-Voltage Bus Converter: Modeling and Control

Design and Implementation of an Accurately Regulated Multiple Output ZVS DC–DC Converter

Design of an Accurately Regulated Multiple Output ZVS DC/DC Converter

Research of an Active Clamping Current-fed Half-bridge Converter with Input Parallel and Output Series

Small Signal Modeling And Analysis Of Interleaved Active-Clamp Forward Converter With Parallel Input And Series-Parallel Output

Modeling and Control of Quasi-Parallel Sigma DC–DC Converter for Single-Stage 48-V Voltage Regulator

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

A Novel Modular Sigma DC/DC Converter with a Wide Input Voltage Range

Current-Feed Single-Switch Forward Resonant DC Transformer (DCX) with Secondary Diode-Clamping.

Modeling and Analysis of 2/3-Level Dual-Active-Bridge DC-DC Converters with the Five-Level Control Scheme

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

A Novel Modulation Scheme and a DC-Link Voltage Balancing Control Strategy for T-Type H-Bridge Cascaded Multilevel Converters

Modeling and Triple-Loop Control of ZVS Grid-Connected DC/AC Converters for Three-Phase Balanced Microinverter Application

Single-Phase AC-DC Converter With Dual-Output Rectifier, Dual-Input DC Transformer, and Voltage-Split/Sigma Principle

A Series-Arm Modular Multilevel DC/DC Converter with Variable Duty Cycle Quasi-Square-Wave Modulation for ZVS Operation

Modeling and Decoupled Control of A Non-Isolated High Step-Up/Down Bidirectional Dc-Dc Converter

Large- and Small-Signal Average-Value Modeling of Dual-Active-Bridge DC–DC Converter With Triple-Phase-Shift Control

Dual-Voltage-Rectifier-Based Single-Phase AC–DC Converters with Dual DC Bus and Voltage-Sigma Architecture for Variable DC Output Applications

Small-Signal Discrete-time Modeling and Digital Control of the Bi-directional DC/DC Converters

Analysis and Design of an Input-Series Two-Transistor Forward Converter for High-Input Voltage Multiple-Output Applications.

Dynamic Modeling and Controller Design for a Single-Stage Single-Switch Parallel Boost-Flyback–Flyback Converter