Abstract:Constrained by the transimpedance limit, the conventional 1-stage shunt-feedback transimpedance amplifier (1S-SF-TIA) suffers poor noise and gain at higher data rates. In this paper, we propose to use a multi-stage stagger-tuned amplifier (MSTA) to constitute TIA (MSTA-TIA), which not only transcends the transimpedance limit of 1S-SF-TIA, but also realizes noise reduction in multiple fronts. First, the high-gain MSTA enables 17X TIA gain over 1S-SF-TIA, which effectively suppresses the white noise. Second, the MSTA realizes at least 2.8X similar to 1.6X lower noise than the conventional multi-stage amplifier, which is essential to form low-noise TIA since the amplifier noise usually dominates. Third, the TIA built upon the 3-stage STA also shows steeper out-of-band roll-off to enable high-frequency noise reduction. Overall, the MSTA-TIA achieves 6.9X and 1.9X noise power reduction over conventional single-stage and multi-stage SF-TIAs. As a demonstration, a 10 Gb/s optical receiver front-end prototype employing proposed MSTA-TIA topology is implemented in a standard 0.18 mu m CMOS technology. It achieves transimpedance gain of 68.3dB Omega, electrical bandwidth of 8.5GHz, and excellent input-referred noise current of 0.97 mu Arms. The chip occupies 0.78 mm(2) while consuming 43 mA from 1.8 V power supply. The low-noise design methodology in this paper empowers mature CMOS to compete with SiGe to make low-noise high-gain optical IC.

A Low-Noise Stacked Differential Optical Receiver in 0.18-μm CMOS

A Low-Noise Stacked Differential Optical Receiver in 0.18-m CMOS

A Robust Differential 4x28gb/s Stacked Optical Receiver in 28nm CMOS Realizing Crosstalk Suppression and Power Supply Rejection

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Stacked Multi-Channel Receiver Architecture for Power-Efficient High-Speed Optical Links

A Stacked 4×25 Gb/s Optical Receiver in 28 Nm CMOS with 0.154 Mw/gb/s Power Efficiency

A compact, fully differential D-band CMOS amplifier in 65nm CMOS

A Low-Noise Design Technique for High-Speed CMOS Optical Receivers

A 10-Gb/s Optical Receiver with Sub-Microampere Input-Referred Noise

Design of a Low Power 60ghz OOK Receiver in 65nm CMOS Technology

A 25gb/s Low-Noise Optical Receiver in 0.13 Μm SiGe BiCMOS.

A Fully-Integrated 25gb/s Low-Noise TIA+CDR Optical Receiver Designed in 40Nm-Cmos.

A 10-Gb/s Low-Power Inverter-Based Optical Receiver Front-End in 0.13-Μm CMOS Process

Low-Noise Broadband CMOS TIA Based on Multi-Stage Stagger-Tuned Amplifier for High-Speed High-Sensitivity Optical Communication.

A Low-Noise 56gbps Pam-4 Linear Optical Receiver In 40nm Cmos

A Low-Noise Analog Frontend with Large PD Capacitance Tolerance in 65-Nm CMOS for Optical Receivers

An Area-Efficient and Programmable 4 × 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 µm SiGe BiCMOS

Design of a 12-Channal 120-Gb/s Optical Receiver Front-End Amplifier in 0.18-Im CMOS Technology

An Area-Efficient and Programmable 4 x 25-to-28.9 Gb/s Optical Receiver with DCOC in 0.13 m SiGe BiCMOS

Low-Noise High-Linearity 56Gb/s PAM-4 Optical Receiver in 45nm SOI CMOS

CMOS 1.4 THzΩ 155 Mb/s differential transimpedance preamplifier for optical receiver