Abstract:This work reports in first time a 100-Gb/s, ultra-low noise, variable gain multi-stagger tuned transimpedance amplifier (VGMST-TIA) over the D-band performance. The whole work is binding into two phases. The first phase involves the modeling and characterization of graphene field-effect transistor (GFET) with an optimized transition frequency of operation. While in the second phase, a TIA design employs a T-shaped symmetrical L-R network at the input, which mitigates the effect of photo diode capacitance and achieves a D-band of operation. The proposed work uses a VGMST to establish TIA, which realizes optimum noise performance. The high gain 3-stage VGMST-TIA effectively minimizes the white noise and illustrates a sharp out-of-band roll-off to achieve considerable noise reduction at high frequencies. The active feedback mechanism controls the transimpedance gain by tuning the control voltage which results better group delay. Besides, an L-C circuit is employed at the output to enhance bandwidth. The full TIA is implemented and fabricated using a commercial nano-manufacturing 9-nm graphene film FET on a silicon wafer using 0.065-μm process. The TIA achieves a flat transimpedance gain of 61.2 dBΩ with ± 9 ps group delay variation over the entire bandwidth. The proposed TIA measured an impedance bandwidth of 0.2 THz with ultra-low input-referred noise current density of 2.03 pA/√Hz. The TIA supports a 100-Gb/s data transmission due to large bandwidth; therefore, a bit-error-rate (BER) less than 10<sup>−12</sup> is achieved. The chip occupies an area of 0.92 * 1.34 mm<sup>2</sup> while consuming power of 21 mW under supply of 1.8 V.

Low-Noise Broadband CMOS TIA Based on Multi-Stage Stagger-Tuned Amplifier for High-Speed High-Sensitivity Optical Communication.

An Inductorless Transimpedance Amplifier Design for 10 Gb/s Optical Communication Using 0.18-Μm CMOS

A Low-Noise Design Technique for High-Speed CMOS Optical Receivers

A 2.5 Gb/s CMOS Low Noise Transimpedance Amplifier with Active Feedback

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A 44gbit/s Wide-Dynamic Range and High-Linearity Transimpedance Amplifier in 130nm BiCMOS Technology

A 10-Gb/s Optical Receiver with Sub-Microampere Input-Referred Noise

10 Gb/S 1.95 Mw Active Cascode Transimpedance Amplifier for High Speed Optical Receivers

A Single-to-differential Broadband Transimpedance Amplifier for 12.5 Gb/s Optical Links.

A 224-Gb/s Inverter-Based TIA with Interleaved Active-Feedback and Distributed Peaking in 28-Nm CMOS for Silicon Photonic Receivers

A 61.2-dBΩ, 100 Gb/s Ultra-Low Noise Graphene TIA over D-Band Performance for 5G Optical Front-End Receiver

A 20-Gb/s CMOS Cross-Coupled Dual-Feedback Loop Transimpedance Amplifier

Area-efficient CMOS transimpedance amplifier for optical receivers

Signal Integrity Augmentation Techniques for the Design of 64-Gbaud Coherent Transimpedance Amplifier in 90-Nm SiGe BiCMOS

A Fully-Integrated 25gb/s Low-Noise TIA+CDR Optical Receiver Designed in 40Nm-Cmos.

A 25gb/s Low Noise 65nm CMOS Receiver Tailored to 100GBASE-LR4.

Design of a highly stable TIA for 2.5Gb/s burst mode optical receiver

A 29.5 Dbm OOB IIP3 TIA Based on a Two-Stage Pseudo-Differential OTA with R-C Compensation and Cascode Negative Resistance

CMOS 1.4 THzΩ 155 Mb/s differential transimpedance preamplifier for optical receiver

A 12.5 Gb/s 1.38 mW all-inverter-based optical receiver with multi-stage feedback TIA and continuous-time linear equalizer

A Low-Noise Stacked Differential Optical Receiver in 0.18-m CMOS