Abstract:Plasma probes are simple and inexpensive diagnostic tools for fast measurements of relevant plasma parameters. While in earlier times being employed mainly in relatively cold laboratory plasmas, plasma probes are now routinely used even in toroidal magnetic fusion experiments, albeit only in the edge region, i.e., the so-called scrape-off layer (SOL), where temperature and density of the plasma are lower. To further avoid overheating and other damages, in medium-size tokamak (MST) probes are inserted only momentarily by probe manipulators, with usually no more than a 0.1 s per insertion during an average MST discharge of a few seconds. However, in such hot and high-density plasmas, their usage is limited due to the strong particle fluxes onto the probes and their casing which can damage the probes by sputtering and heating and by possible chemical reactions between plasma particles and the probe material. In an attempt to make probes more resilient against these detrimental effects, we tested two graphite probe heads (i.e., probe casings with probes inserted) coated with a layer of electrically isolating ultra-nano-crystalline diamond (UNCD) in the edge plasma region of the Experimental Advanced Superconducting Tokamak (EAST) in Hefei, People’s Republic of China. The probe heads, equipped with various graphite probe pins, were inserted frequently even into the deep SOL up to a distance of 15 mm inside the last closed flux surface (LCFS) in low- and high-confinement regimes (L-mode and H-mode). Here, we concentrate on results most relevant for the ability to protect the graphite probe casings by UNCD against harmful effects from the plasma. We found that the UNCD coating also prevented almost completely the sputtering of graphite from the probe casings and thereby the subsequent risk of re-deposition on the boron nitride isolations between probe pins and probe casings by a layer of conductive graphite. After numerous insertions into the SOL, first signs of detachment of the UNCD layer were noticed.

UNCD-Armoured Probes for Diagnostics in Hot and Hazardous Plasmas

Diamond-Coated Plasma Probes for Hot and Hazardous Plasmas

Design, construction, and calibration of a three-axis, high-frequency magnetic probe (B-dot probe) as a diagnostic for exploding plasmas

Langmuir probe diagnostic suite in the C-2 field-reversed configuration

Surface Diversifying and Deuterium Retention Characteristics of Doped Graphite with SiC Coating Exposed to Plasma Discharges in EAST Tokamak

Double Flush-Mounted Probe Diagnostics and Data Analysis Technique for Argon Glow Discharge Plasma

Analysis of thermal plasma diagnostics based on enthalpy probe system

Flush-Mounted Probe Diagnostics for Argon Glow Discharge Plasma

Plasma-target surface interaction during non-equilibrium plasma irradiation at atmospheric pressure: Generation of dusty plasma

The Use Of A Symmetrical Triple Probe For Direct Reading Of Plasma Parameters In A Planar Pcvd Reactor

Improved analysis techniques for cylindrical and spherical double probes

Experimental Investigation on High Heat Flux Plasma Parameters of HIT-PSI Device in Argon Discharges

Design of a Unidirectional Reception and High Temperature Resistance Electric Field Probe for Measuring the Internal Electric Field of Plasma

Scanning Internal Probe for Plasma Particle, Fluctuation, and LIF Tomographic Measurements

Probing Properties of Cold Radiofrequency Plasma with Polymer Probe

A newly designed actively water-cooled Langmuir probe for tokamak devices

LOW TEMPERATURE PLASMA PROBE AND METHODS OF USE THEREOF

Application of a large wall electric probe (LWEP) for plasma and ambient gas studies

Studies of a hollow cathode discharge using mass spectrometry and electrostatic probe techniques

Plasma probe characteristics in low density hydrogen pulsed plasmas

The Techniques of Single Probe and Emission Spectroscopy Diagnostics in Low Temperature Argon Plasmas