Abstract:SnO2 has the advantages of excellent photostability and can be prepared at low-temperature below 200 degrees C.It is regarded as one of the excellent materials for the electron transport layer, and widely used in efficient andstable planar heterojunction perovskite solar cells. In this work, the low-cost, dense and uniform SnO2 electrontransport layer is prepared by spin coating at low temperature (150 degrees C) for perovskite solar cells with astructure of FTO/SnO2/CH3NH3PbI3 (MAPbI3)/Spiro-OMeTAD/Au. The crystallization and photoelectricproperties of SnO2 electron transport layers prepared at different concentrations (2.5%-10%) at 150 degrees C, and theinfluences of SnO2 electron transport layers on the formation of perovskite films and the performances ofperovskite solar cells are discussed. By analyzing the scanning electron microscope (SEM), ultraviolet-visiblelight absorption spectrum (UV-Vis) and transmission spectrum of the SnO2 film, it is found that the coverageand light transmittance of the substrate and band gap of the SnO2 film increase as the SnO2 content increases,while the absorbance decreases. By analyzing the SEM, UV-Vis, X-ray diffraction (XRD) and steady-statephotoluminescence spectrum (PL) analysis of the SnO2/MAPbI3 thin film, it is found that the MAPbI3deposited on the SnO2 layer with a concentration of 7.5% is uniform and pinhole-free, has the largest particlesize and the best crystallinity, as well as more effective charge extraction capability and transport capability.By analyzing the electrochemical impedance (EIS) and external quantum efficiency (EQE) of the device, theSnO2 electron transport layer with a concentration of 7.5% has better interface contact and lower interfaceresistance, which is beneficial to reducing the recombination of carriers and improving the photoelectricconversion capability, The perovskite solar cells based on SnO2 layer prepared with a concentration of 7.5%reaches a photoelectric conversion efficiency of 15.82% (Voc = 1.06 V, Jsc = 21.62 mA/cm2, FF = 69.40%), Afterstoring for 600 h in ambient air ((25 +/- 5) degrees C, RH>70%) without encapsulation, its efficiency remains 92% of theinitial efficiency. At the same time, we prepare flexible devices on flexible substrates (TIO/PEN) by using SnO2precursor with a concentration of 7.5%, which exhibits good photovoltaic performance and achieves aphotoelectric conversion efficiency of 13.12%, and storage time for 84 d in ambient air ((30 +/- 5) degrees C, RH>70%)without encapsulation, its efficiency remains 48% of the initial efficiency. The PCE retains 78% of the initialefficiency after 1000 bending cycles with a bending radius of 3 mm. The study of optimizing the concentrationof SnO2 has laid a foundation for improving the performance of flexible perovskite solar cells.

Coagulation and crystallinity in Sn (II, IV) oxide as an electron transfer layer

OPTICAL AND ELECTRICAL PROPERTIES OF SnO2:Sb THIN FILMS DEPOSITED BY SOL-GEL PROCESS

Thermo-oxidative stability of SnO crystals and obtained few layer crystals by mechanical exfoliation

Performance of SnO2 Thin Film Prepared by CWD Technique on Different Substrates for Device Applications: An Innovative Approach

Managing Interfacial Defects and Charge-Carriers Dynamics by a Cesium-Doped SnO2 for Air Stable Perovskite Solar Cells

Non-toxic and rapid chemical bath deposition for SnO2 electron transporting layers in perovskite solar cells

Energetically Favored Formation of SnO2 Nanocrystals As Electron Transfer Layer in Perovskite Solar Cells with High Efficiency Exceeding 19%

Preparation of TiO2/SnO2 thin films by sol-gel method and periodic B3LYP simulations

A novel synthesis of tin oxide thin films by the sol-gel process for optoelectronic applications

Investigating the properties of tin-oxide thin film developed by sputtering process for perovskite solar cells

Enhancing the Performance of Nanocrystalline SnO2 for Solar Cells through Photonic Curing Using Impedance Spectroscopy Analysis

Hybrid potentiodynamic/potentiostatic electrodeposition of thin and compact tin dioxide on indium tin oxide electrodes

Microstructural, optical, and morphological investigations of SnO2 nanomaterials grown by microwave assisted sol gel method

Ultralow‐temperatureSnO2 Electron Transport Layers Fabricated by Intermediate‐controlled Chemical Bath Deposition for Highly Efficient Perovskite Solar Cells

Optimized SnO2 preparation and coherent interlayers for enhanced charge dynamics and efficient perovskite photovoltaics

Heterovalent Samarium Cation‐Doped SnO2 Electron Transport Layer for High‐Efficiency Planar Perovskite Solar Cells

The role of vast off-stoichiometry of SnSe thin film on structural, morphological, optical, and electrical properties for photovoltaic applications

Structural and optical properties of rare earth doped Zn2SnO4 nano-composites prepared via Sol-gel synthesis

Sol-gel spin-coated Y-doped SnO 2 nanostructured thin films for various optoelectronic device applications

Exploring the Post-Annealing Influence on Stannous Oxide Thin Films via Chemical Bath Deposition Technique: Unveiling Structural, Optical, and Electrical Dynamics

Low-temperature preparation of SnO2 electron transportlayer for perovskite solar cells