Abstract:The research on working fluids of refrigerant/absorbent mixture is important for the development of the absorption refrigeration area. R290/POE-oil mixture is a new potential working fluid, in which R290 (propane) is the refrigerant and POE oil is the absorbent. This refrigerant/oil working fluid has a wide operating range, low generation temperature, and no corrosion to metals. Flow boiling heat transfer performance of the new working fluid in smooth horizontal tubes has been experimentally investigated in this paper. The R290 concentration for the experimental working fluid was selected as 11 wt%. The test sections were horizontal smooth stainless steel annular tubes with outer diameters of 6, 8 and 10 mm. The boiling saturation pressures in the test sections coincided with the actual operation of the absorption refrigeration cycle, which were set as 1.2 MPa, 1.3 MPa, 1.4 MPa, respectively, corresponding to boiling temperatures 55.3 °C, 58.7 °C, 62.5 °C. The mass fluxes were 166 kg m−2s−1, 221 kg m−2s−1, 276 kg m−2s−1, 332 kg m−2s−1 and 387 kg m−2s−1. The effects of heat flux, vapor quality, mass flux, boiling temperature and tube diameter on the flow boiling heat transfer coefficient were displayed and analyzed. Experimental results show that heat flux, mass flux and vapor quality have obvious effects on the coefficients; the nucleate boiling mechanism plays an important role, and the convective boiling mechanism plays a significant role in the boiling process. The present study is of good significance to the application of R290/POE-oil working fluid and the design and optimization of the finned-tube generators in absorption refrigeration systems.

Oil Solubility Effect on Evaporation Performance with R290 As Refrigerant

Oil Presence Effect on Thermodynamic Performance of the Evaporator Working with R290

Effect of Refrigerant/oil Solubility on Thermodynamic Performance of the Evaporator Working with R600a and DME

Experimental Investigation on the Solubility of R290 in Two Mineral Oils

Viscosity Measurement and Correlation of Saturated Solutions of R-290 with Three Lubricants

Solubility And Miscibility For The Mixture Of (Ethyl Fluoride Plus Polyol Ester Oil)

Impact of oil presence on the evaporator enthalpy working with R1234ze(E) and R1234yf

Study on Flow Boiling Heat Transfer Characteristics of R161/oil Mixture Inside Horizontal Micro-Fin Tube

Experimental Analysis on R290 Solubility and R290/oil Mixture Viscosity in Oil Sump of the Rotary Compressor

Theoretical Investigation on the Performance of a Modified Refrigeration Cycle Using Binary Zeotropic Hydrocarbon Mixture R170/R290

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Solubilities of R-1233zd(E) in Three Lubricating Oils and Impact of Oil Retention on the Evaporator Performance

Performance and Refrigerant Mass Distribution of a R290 Split Air Conditioner with Different Lubricating Oils

Experimental Study on the Oil Return Characteristics of Miscible or Partially Miscible Oil in R290 Room Air Conditioners

Experimental investigation on the mutual solubility of R134a/R290 with lubricant

Refrigerant migration and oil sump viscosity change of R290 high-pressure rotary compressor during shutdown process

Surface Tension of R290/Lubricant Oil Mixtures from 243 to 333 K

Oil Retention and Its Mass Distribution Within a R290 Room Air Conditioner Using Miscible or Partially Miscible Oils

Solubility of R-1233zd(E) in PVE 68 Oil and the Oil Presence Impact on Evaporator Performance

Phase Behavior and Enthalpies of Binary Mixtures of R-1243zf with PAG 68, POE 85 and PEC4 Oils

Experimental evaluation on flow boiling heat transfer of R290/POE-oil working fluid for absorption refrigeration in smooth horizontal tubes