Abstract:With the rapid development of the semiconductor industry, the feature size of integrated circuits (ICs) is continuously getting smaller and smaller. Although traditional optical lithography and extreme ultraviolet (EUV) lithography can fabricate products with 5-nm feature size, the production cost is quite high. As a candidate of next-generation lithography, ultraviolet nanoimprint lithography (UV-NIL) can also achieve high-resolution imprints at a lower cost. Based on contact mechanics, the filling mechanism and imprint quality of UV-NIL were examined using high-resolution stamps with different feature sizes of 3 nm, 4 nm, and 5 nm. It was found that UV-NIL could successfully replicate patterns with feature sizes down to 3 nm; however, the imprinting process was more complicated. Among the selected nine stamps, the replications of 4-nm and 5-nm feature sizes had a relatively uniform residual layer and a symmetric contact pressure, whereas the replications of 3-nm feature size had an asymmetric contact pressure, resulting in an asymmetric residual layer. In order to obtain a more uniform residual layer with higher-quality imprinting, the pressure applied to the left and right sides of a stamp should be appropriately changed. The pattern density of a stamp had a certain influence on the contact pressure. As the pattern density increased, the contact pressure tended to be uniform; however, when the pattern density exceeded 0.5, the situation became worse. This research can provide guidance for promoting the development of UV-NIL in the direction of high-resolution pattern replication.

Multi-scale Analysis Approach for SU-8 in Ultraviolet Nanoimprint Lithography Demolding Process

Hydrodynamic and Solid Mechanics Analysis of Capillary Force-Induced Mold Deformation in Sub-10 nm UV Nanoimprint Lithography

Molecular dynamics simulation study of the degradation of polymer nanopatterns created by nanoimprint

Hydrodynamics and solid mechanics structural analysis of mold deformation in nanoimprint lithography

Numerical Investigation for the Resin Filling Behavior during Ultraviolet Nanoimprint Lithography of Subwavelength Moth-Eye Nanostructure

Coarse-Grain Simulations of the Polymer Filling Process in Nanolithography

Effects of Mold Geometries and Initial Resist Thickness on Filling Behavior in UV-Nanoimprint Lithography

Assessment of release properties in UV nanoimprint lithography using high-aspect-ratio nanoscale molds

Optimization of Control Parameters in Micro Hot Embossing

UV-assisted nanoimprint lithography: the impact of the loading effect in silicon on nanoscale patterns of metalens

High Resolution Soft Mold for UV-curing Nanoimprint Lithography Using an Oxygen Insensitive Degradable Material

Quantitative evaluation of residual resist in electron beam lithography based on scanning electron microscopy imaging and thresholding segmentation algorithm

Surface energy-tunable iso decyl acrylate based molds for low pressure-nanoimprint lithography

Fabrication of Large-Area Nanostructures Using Cross-Nanoimprint Strategy

Fabrication of Flexible Mold for Hybrid Nanoimprint-Soft Lithography

Nondestructive Demolding of Structure-Designable High-Aspect-Ratio Nanoimprint Template

Research on the Filling Process of Ultraviolet Nanoimprint Lithography with High-Resolution Stamps

Optimal conditions for controllable one-dimensional nanomold by selective etching of multilayer film

Stability And Surface Topography Evolution In Nanoimprinted Polymer Patterns Under A Thermal Gradient

Process Research of Novel UV Nanoimprint Lithography Resist with Enhanced Anti-Sticking Property

Scanning probe lithography for nanoimprinting mould fabrication