Abstract:Traditional vanadium extraction process, which involves H2SO4 stripping after solvent extraction followed by ammonium vanadate precipitation, faced the issues of large amount of reagent consumption and discharge of ammonia contaminated wastewater. Hydrogen peroxide stripping and precipitation of vanadium products by heating process was considered as a novel alternative for H2SO4 stripping - ammonium vanadate precipitation route due to the ammonia-free wastewater and high efficiency. However, it was found that the V stripping efficiency was in the range of 54.9% similar to 97.7% during the pilot test of 3-stage counter-current stripping, which was extremely unstable, as the high stripping efficiency (>95%) could only be achieved in a very short operation time (within 30 s). To solve these issues, the ion species transformation and the stripping mechanism of V with H2O2 were systematically investigated. In this study, experimental results demonstrated that re-extraction led to a decrease of stripping efficiency. The use of D2EHPA alone without TBP as a modifier had a clear effect on prolonging the duration of maximum stripping efficiency at the optimal conditions so that the continuous operation of the pilot test was possible. The optimal stripping conditions were a molar ratio of H2O2:V of 4:1, phase ratio (O/A) of 3:1, temperature of 20 degrees C, stripping time of 8 min and the operation time of 3 min which resulted a similar to 98% V stripping efficiency. In addition, the precipitation of vanadium products by heating, proposed in this work was a cleaner and more efficient V precipitation procedure that didn't require any reagents and produced no wastewater. Eventually, heating the strip liquor at 100 degrees C for 1 h resulted a precipitation efficiency of 96% V. The intermediate precipitated products (V5O12 center dot 6H(2)O and V10O24 center dot 12H(2)O) were roasted to obtain V2O5 with a purity of >99%. Finally, the new process saves 885.2 $/t V2O5 compared with the traditional process according to the cost analysis. The research results provide an efficient, clean and economical process for recovering V2O5 from titanium-white waste.

A Clean Ammonia-Free Vanadium Recovery Process for Titanium-White Waste Using D2EHPA Extraction, Hydrogen Peroxide Stripping, Precipitation and Calcination to Produce V2O5

An extraction process to recover vanadium from low-grade vanadium-bearing titanomagnetite

Selective Solvent Extraction of Vanadium Over Chromium from Alkaline Leaching Solution of Vanadium Slag by D2EHPA/TBP

Recovery of Vanadium from Carbonated Solution by Extraction with Transformed Aliquat 336 and Stripping-Precipitation

Tuning of vanadium valence for value-added recycling and utilization of vanadium from spent Selective Catalytic Reduction Catalysts

Cleaner and cost-efficient hydrometallurgical process for extraction of vanadium from Bayer vanadium sludge based on BaSO4, NaOH, ammonium, and water circulation

Extraction of Vanadium from LD Converter Slag by Pressure Leaching Process with Titanium White Waste Acid

A Sustainable Technique to Prepare High-Purity Vanadium Pentoxide via Purification with Low Ammonium Consumption

Recovery of vanadium from direct acid leaching solutions of weathered crust vanadium‐titanium magnetite via solvent extraction with N235

Parametric Study of Vanadium Extraction Process from Refining Tailings of Crude Titanium Tetrachloride

Clean and cost-efficient preparation of vanadium electrolyte from the vanadium-rich solution of black shale by solvent extraction

An effective and cleaner process to recovery iron, titanium, vanadium, and chromium from Hongge vanadium titanomagnetite with hydrogen-rich gases

Cyclic metallurgical process for extracting V and Cr from vanadium slag: Part I. Separation and recovery of V from chromium-containing vanadate solution

Short-Process Preparation of High-Purity V2O5 from Shale Acid Leaching Solution via Chlorination

Vanadium Recovery from Spent SCR Denitration Catalyst by Reductive Acid Leaching and Ammonium Precipitation

Efficient separation of vanadium, titanium, and iron from vanadium-bearing titanomagnetite by pressurized pyrolysis of ammonium chloride-acid leaching-solvent extraction process

The Recovery of Vanadium Pentoxide (V2O5) from Spent Catalyst Utilized in a Sulfuric Acid Production Plant in Jordan

Recovery of vanadium from vanadium slag with high phosphorus content via recyclable microemulsion extraction

Two-stage cyclic ammonium sulfate roasting and leaching of extracting vanadium and titanium from vanadium slag

Removing trace chromium from high concentration vanadium solution by photoreduction deposition with Ti–Zr solid solution

Extraction and separation of Fe and Ti from extracted vanadium residue by enhanced ammonium sulfate leaching and synthesis of LiFePO4/C for lithium-ion batteries