Abstract:TiAl intermetallic alloys have attracted considerable attention in aerospace applications over the last few decades owing to their low density and superior mechanical properties at high temperatures. However, these alloys are also known as difficult-to-machine materials that hinder efficient manufacturing. This study presents a systematic investigation on the machinability of TiAl alloys with three types of microstructures obtained by different heat treatment parameters. These were classified as near-gamma (NG), duplex (DP), and fully lamellar (FL). The machinability was evaluated based on the cutting forces and machined surface roughness. The material with α2/γ lamellar structures (FL) exhibited the lowest cutting force (3.21 N). However, produced a rougher surface (80 nm Ra) as compared to the NG microstructure (4.69 N and 47 nm Ra). Electron backscattering diffraction (EBSD) evaluation of the primary deformation zone in the cutting chips revealed that insufficient heat energy was converted from plastic deformation for recrystallization or β+γ→α2 phase transformation to occur. This indicated that the deformation mechanisms were significantly dependent upon the plasticity. The NG microstructure demonstrated a higher degree of plasticity in the primary deformation zone, which was attributed to the combined effect of super-dislocation decomposition, ordinary dislocation slip, and refined mechanical twins with preferred orientation along the < 11 2 ¯ > {111} crystallographic orientation. Conversely, the FL microstructure exhibited brittleness during chip formation due to the weak bonding force between hexagonal α2 and tetragonal γ phases that led to preferential micro-cracking along each interface. Reducing the crystal orientation is conductive for improving machined surface quality. The notion of enhanced brittleness to explain the reduction in cutting forces due to the dissipation of energy through fracture was supported with numerical simulations. Microscopic evaluation was used to understand the deformation differences of the equiaxed γ grain and α2/γ lamellar microstructure during micro-cutting. Additionally, enhanced the understanding of the deformation mechanism of these multi-phase alloys.

Machinability of c-TiAl: A review

Microstructural modulation of TiAl alloys for controlling ultra-precision machinability

A review on machining Ti–5Al–5V–5Mo–3Cr alloy using defined geometry tools

Overcoming challenges: advancements in cutting techniques for high strength-toughness alloys in aero-engines

Comparative study on machinability and surface integrity of γ-TiAl alloy in laser assisted milling

Study on Cutting Processing Technology of Titanium Alloy

Titanium alloys and their machinability—a review

A critical review of advanced techniques to improve machining of titanium alloy (grade 5)

The State of the Art in Machining Additively Manufactured Titanium Alloy Ti-6Al-4V

A Comprehensive Review on Machining of Titanium Alloys

High surface integrity machining of typical aviation difficult-to-machine material blade

Surface micro-texture and tribological properties in longitudinal-torsional ultrasonic-assisted milling Ti2AlNb

Advancing Machinability of Ti-6Al-4V Alloy: A Sustainable Integrated Approach

A Comprehensive Review of Machinability of Difficult-to-Machine Alloys with Advanced Lubricating and Cooling Techniques

The influence of induction-assisted milling on the machining characteristics and surface integrity of γ-TiAl alloys

Computational investigation on the surface cutting of γ-TiAl alloy

High-strength titanium alloys for aerospace engineering applications: A review on melting-forging process

Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review

Research and Development of Some Advanced High Temperature Titanium Alloys for Aero-engine

Review of improvement of machinability and surface integrity in machining on aluminum alloys

Design, Processing, Microstructure, Properties, and Applications of Advanced Intermetallic TiAl Alloys