Abstract:True triaxial tests (sigma(1) >= sigma(2) >= sigma(3)) were conducted on the Zigong sandstone with a relatively low porosity of similar to 6.5% with the aim of assessing the influence of the intermediate principal stress o on the strength and deformability. Three series of true triaxial tests (sigma(3) = 0, 20, and 60 MPa) were performed. Within each series, sigma(2) was planned to be varied from sigma(2) = sigma(3) to sigma(2) = sigma(1) from test to test. For each test, sigma(1) was raised monotonically to failure while sigma(2) and sigma(3) were kept constant and the post-peak behavior has been captured. It is found that the strain in the sigma(3) -direction is always larger than that in the sigma(2)-direction under true triaxial stresses, which is attributed to the stress-induced tensile microcracks aligned with the sigma(1)-sigma(2) plane. For a constant sigma(3), the dilatant strain in the sigma(2) -direction is progressively suppressed and becomes compactive as sigma(2) raises from sigma(2) = sigma(3) to sigma(2) = sigma(1). Based on a modified Hoek-Brown failure criterion with three stress invariants, the best fitting brittle strength envelope reveals that the o effect on rock strength, i.e., the ascending-then-descending trend for a given sigma(3), is the combined effect of mean stress and Lode angle. In the series of biaxial tests (sigma(3) =0 MPa), macro tensile fractures that parallel to the sigma(1)-sigma(2) plane develop regardless of sigma(2), displaying a failure plane angle of approximately 90 degrees. As sigma(3) is raised, failure plane angle generally decreases. When sigma(3) = 20 MPa, the failure plane angle generally increases with o while there is no evident dependence on o when sigma(3) = 60 MPa. Comparisons with the other two sandstones with higher porosity reveal that porosity exerts critical control on the brittle strength and that the o effect on deformability is also the result of two competing effects induced by mean stress and Lode angle. It is also found that the residual strength data facilitate the prediction of brittle-ductile transition pressure when sigma(2) = sigma(3 ) in spite of relatively low sigma(3) level, which matches well with the empirical relation proposed by Mogi.(1)

Mechanical Deformation, Acoustic Emission Characteristics, and Microcrack Development in Porous Sandstone During the Brittle–Ductile Transition

Experimental investigation and micromechanical modeling of the brittle-ductile transition behaviors in low-porosity sandstone

Study on Acoustic Emission and Crack Propagation Characteristics of Single-Fissured Sandstone with Different Angles Under Uniaxial Compression

Experimental and numerical investigations on the mechanical behavior of sandstone subjected to gas undrained triaxial compression

Cracking process and acoustic emission characteristics of sandstone with two parallel filled-flaws under biaxial compression

Experimental Study on Mechanical Behavior, Fracture Characteristics, and Acoustic Emission Damage Characteristics of Sandstone Under Triaxial Multistage Stress Disturbance

Systematic detection and evaluation of cracking behavior of flawed brittle sandstones with AE and 3D-DIC techniques

Thermal-hydraulic-mechanical coupling mechanical behavior and acoustic emission characteristics of deep sandstone

Experimental investigation on mechanical, acoustic, and fracture behaviors and the energy evolution of sandstone containing non-penetrating horizontal fissures

Brittleness evaluation and damage evolution of sandstone under hydromechanical coupling

Damage Evolution and Acoustic Emission Characteristics of Sandstone under Freeze-Thaw Cycles

Strength and Deformability of a Low-Porosity Sandstone under True Triaxial Compression Conditions

Compressive Fracture Behavior and Acoustic Emission Characteristics of Sandstone under Constant Crack Water Pressure

Mechanical Responses of a Porous Red Sandstone to Quasi-Static Cyclic Loads Under Uniaxial Compression

Research and analysis of the impact of the pore structure on the mechanical properties and fracture mechanism of sandstone

Acoustic Emission Associated with Self-Sustaining Failure in Low-Porosity Sandstone under Uniaxial Compression

Experimental Study on the Effect of Brittleness on the Dynamic Mechanical Behaviors of the Coal Measures Sandstone

Progressive Failure Characterization of Sandstone from Yingjinshan Area in Qinghai-Tibet Plateau

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress

Dynamic Mechanical Properties and Failure Characteristics of Sandstone with Pre-Flaws Parallel to the Loading Direction

Experimental study on mechanical and acoustic emission characteristics of sedimentary sandstone under different loading rates