Abstract:Silicon Photomultiplier (SiPM) has been demonstrated to be a high performance PET sensor as alternative to conventional photomutiplier tubes. The aim of this work is to develop a PET detector module with compact SiPM device which consists of 3x3 SiPM arrays (4x4 pixels each array, 3.17x3.17 mm(2) each pixel). A compact design of readout electronics is proposed based on discretized position-sensitive readout circuits (DPC) and time based readout ASIC. The function of the ASIC is to convert all signals' energy and timing information into digital timing pulses which can be processed by back-end simple Time-Digital-Convertor (TDC). So we get highly integrated electronics because the traditional Analog-Digital-Convertor (ADC) and Constant-Fraction-Discriminator (CFD) are replaced. A temperature-dependent gain control module including a microcontroller, a DAC and a DC-DC converter is designed to stabilize the gain of SiPM arrays against the variance of ambient temperature, which is based on the temperature sensor and serial identification chip intergrated in the SiPM array package. An preliminary experimental study was conducted, in which one SiPM array was coupled to a 6x6 LYSO crystal block. With a resistor charge-division chain readout circuit, a flood histogram map was acquired in which the crystals were clearly identifiable. With the correction of the gain control module, the maximum gain drift of SiPM decreases from 79.67% to 11.03% as the temperature varies from 27 degrees C to 50 degrees C. The result indicates that the developed gain control module can contribute to improving the stability of SiPM based PET detector. Through some basic tests, the ASIC has demonstrated good performances of linearity and uniformity. We conclude that the proposed design is feasible for developing a compact SiPM PET detector module.

Proportional Counter array (PCa)-a new concept and its realization

A high rate and high timing photoelectric detector prototype with RPC structure

Large Area Closed Gas Proportional Counter Progress

Study of Gas Amplification Impact on Plateau Curve Characteristics in Boron-Coated Proportional Counters

Design and performance study of a proportional counter for low-energy X-rays

A gaseous proportional counter built from a conventional aluminium beverage can

A Counter Array for Imaging Particle Spectrometer

Design and Testing of a 0.8 V Low-voltage High-rate Prototype Readout ASIC for the Micro-Pattern Gas Detector

An improved design of spark-protected microstrip gas counters (R-MSGC)

The development of segmented electrode thin-film parallel plate avalanche counter (PPAC)

A Portable Readout System for Micro-pattern Gas Detectors and Scintillation Detectors

A High Compression Ratio Channel Multiplexing Method for Micro-pattern Gaseous Detectors

Development of a Parallel-Plate Avalanche Counter with Optical Readout (O-PPAC)

A Large Position-sensitive PPAC

A Real-Size MRPC Developed for CBM-TOF

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

Study of A Multi-Wire Proportional Chamber with A Cathode Strip and Delay-Line Readout

An Extensible Induced Position Encoding Readout Method for Micropattern Gas Detectors

A Prototype Scalable Readout System for Micro-pattern Gas Detectors

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Proportional counters and microchannel plates