Abstract:For gas metal arc welding, the effect of CO2 mixture in a shielding gas on a metal transfer process was investigated through the observation of the plasma characteristics and dynamic behavior at the droplet's growth-separation-transfer by the temperature measurement methods which were suitable respectively to the argon plasma region and the metal plasma region. At the present experimental conditions, the metal transfer process was a spray transfer type with 100%Ar shielding gas. On the other hand, with 85%Ar+15%CO2 shielding gas, the metal transfer process was a globular transfer type in which the arc length was shorter, the width was narrower, and the time interval of the droplet separation was longer. For both shielding gases, the metal plasma region near the arc central axis exhibited 6500-7500 K which was lower than the argon plasma region. With 85%Ar+15%CO2 shielding gas, when the metal droplet grew below the electrode wire, the region below the droplet has a high plasma temperature and a high concentration of iron vapor which surrounded the droplet. The region also exhibited a remarkably high electron number density. At the spray transfer process, the argon plasma region had the electron number density twice higher than the metal plasma region. Meanwhile, at the globular transfer process, the metal plasma region had a higher electron number density than the argon plasma region, which corresponded to a higher electrical conductivity near the arc axis. This means that the electric current goes through the arc axis easier than the spray transfer process. This condition increases the temperature below the droplet. The thermal expansion increases the force preventing the droplet from falling down. In consequence, the metal transfer takes the globular transfer type.

Photographic Analysis and Optical Diagnosis of Kilowatt Microwave Plasma Torch with Air Carrier Gas

High-speed Photographic Analysis of Microwave Plasma Torch Source Behaviour

Optical diagnostics of a low power—low gas flow rates atmospheric-pressure argon plasma created by a microwave plasma torch

Imaging Diagnostics and Gas Temperature Measurements of Atmospheric-Microwave- Induced Air Plasma Torch

Gas Temperature Measurements and Imaging Analysis in Atmospheric-Pressure Microwave Air Induced Plasma Torch

Investigation of a Novel Atmospheric Pressure Microwave Cold Plasma Torch and Its Characteristics

Development of a Novel Kilowatt Microwave Plasma Torch Source for Atomic Emission Spectrometry

Electrical and Spectroscopic Diagnostic of an Atmospheric Double Arc Argon Plasma Jet

Determination of 915-Mhz Atmospheric Pressure Air Microwave Plasma Torch (MPT) Parameters

Characteristics of Microwave Plasma Torch at Atmospheric Pressure

Temperature Distribution and Measurement of Atmospheric Air Microwave Plasma

Optical Spectroscopy Diagnosis of Methane Plasma Generated with Atmospheric Pressure Jet

Electromagnetic Properties of a New Microwave Plasma Torch with Double Resonance Configuration

Studies on Excitation and Rotational Temperatures of an Oxygenshielded Argon Microwave Plasma Torch Source

Mechanisms of Gas Temperature Variation of the Atmospheric Microwave Plasma Torch

The Emission Spectra Diagnosis in Microwave Argon and Argon-Air Plasmas

Measurement of Airblast Atomization of Low Temperature Kerosene with 25 Khz Digital Holography.

In-Situ Diagnosis of Ar Plasma Generated by Unequal Potential Hollow Cathode Discharge

Characterization Of An Atmospheric Double Arc Argon-Nitrogen Plasma Source

Characterization of DC argon plasma jet at atmospheric pressure

Analysis of dynamic plasma behaviors in gas metal arc welding by imaging spectroscopy