Abstract:In a DC plasma spray torch, the plasma-forming gas is the most intensively heated and accelerated at the cathode arc attachment due to the very high electric current density at this location. A proper prediction of the cathode arc attachment is, therefore, essential for understanding the plasma jet formation and cathode operation. However, numerical studies of the cathode arc attachment mostly deal with transferred arcs or conventional plasma torches with tapered cathodes. In this study, a 3D time-dependent two-temperature model of electric arc combined with a cathode sheath model is applied to the commercial cascaded-anode plasma torch SinplexPro fitted with a wide single cathode. The model is used to investigate the effect of the cathode sheath model and bidirectional cathode-plasma coupling on the predicted cathode arc attachment and plasma flow. The model of the plasma-cathode interface takes into account the non-equilibrium space-charge sheath to establish the thermal and electric current balance at the interface. The radial profiles of cathode sheath parameters (voltage drop, electron temperature at the interface, Schottky reduction in the work function) were computed on the surface of the cathode tip and used at the cathode-plasma interface in the model of plasma torch operation. The latter is developed in the open-source CFD software Code_Saturne. It makes it possible to calculate the plasma flow fields inside and outside the plasma torch as well as the enthalpy and electromagnetic fields in the gas phase and electrodes. This study shows that the inclusion of the cathode sheath model in the two-temperature MHD model results in a higher constriction of the cathode arc attachment, more plausible cathode surface temperature distribution, more reliable prediction of the torch voltage and cooling loss, and more consistent thermal balance in the torch.

Electromagnetic Properties of a New Microwave Plasma Torch with Double Resonance Configuration

Development of Microwave Plasma Torch Mass Quadrupole Spectrometer

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

Design and Study of a Large-Scale Microwave Plasma Torch with Four Ports

High-speed Photographic Analysis of Microwave Plasma Torch Source Behaviour

Development of a Novel Kilowatt Microwave Plasma Torch Source for Atomic Emission Spectrometry

Recent Advances in Microwave Plasma Torch Atomic Emission Spectrometry

Cold-model experimental and simulation research of reaction zone of a microwave plasma torch

Current–voltage Characteristics of Hydrogen DC Plasma Torches with Different Sizes in an External Axial Magnetic Field

Determination of 915-Mhz Atmospheric Pressure Air Microwave Plasma Torch (MPT) Parameters

Gas Temperature Measurements and Imaging Analysis in Atmospheric-Pressure Microwave Air Induced Plasma Torch

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Development of a High Resolution Simultaneous Microwave Plasma Torch Spectrometer

Imaging Diagnostics and Gas Temperature Measurements of Atmospheric-Microwave- Induced Air Plasma Torch

Investigation of a Novel Atmospheric Pressure Microwave Cold Plasma Torch and Its Characteristics

Photographic Analysis and Optical Diagnosis of Kilowatt Microwave Plasma Torch with Air Carrier Gas

Experimental study on the characteristics of V‐type arc plasma torch with four electrodes

Temperature Distribution and Measurement of Atmospheric Air Microwave Plasma

Simulation and Design of New Microwae Plasma Source with Slotted Straight Waveguides

Effect of Cathode-Plasma Coupling on Plasma Torch Operation Predicted by a 3D Two-Temperature Electric Arc Model

A high-performance microwave plasma source employing dielectric wedges