Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

Cold-model experimental and simulation research of reaction zone of a microwave plasma torch

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

Development of Microwave Plasma Torch Mass Quadrupole Spectrometer

Electromagnetic Properties of a New Microwave Plasma Torch with Double Resonance Configuration

Design and Study of a Large-Scale Microwave Plasma Torch with Four Ports

Gas Temperature Measurements and Imaging Analysis in Atmospheric-Pressure Microwave Air Induced Plasma Torch

Determination of 915-Mhz Atmospheric Pressure Air Microwave Plasma Torch (MPT) Parameters

Investigation of a Novel Atmospheric Pressure Microwave Cold Plasma Torch and Its Characteristics

Imaging Diagnostics and Gas Temperature Measurements of Atmospheric-Microwave- Induced Air Plasma Torch

Mechanisms of Gas Temperature Variation of the Atmospheric Microwave Plasma Torch

Development of a Novel Kilowatt Microwave Plasma Torch Source for Atomic Emission Spectrometry

Studies on Excitation and Rotational Temperatures of an Oxygenshielded Argon Microwave Plasma Torch Source

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Simulations and experimental results for a microwave plasma system

High-speed Photographic Analysis of Microwave Plasma Torch Source Behaviour

Recent Advances in Microwave Plasma Torch Atomic Emission Spectrometry

Research on the rapid combustion process of butane under microwave discharge

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

Investigation of Electron Density and Temperature in Microwave Plasma Generated by a Cylindrical Teflon Waveguide

Effect of Cathode-Plasma Coupling on Plasma Torch Operation Predicted by a 3D Two-Temperature Electric Arc Model

Simulation and Design of New Microwae Plasma Source with Slotted Straight Waveguides