Abstract:Recently, energy conservation, environmental protection and security are the main factors considered by the automotive manufacturers. Medium-Mn steel with excellent combination of specific strength and ductility have been regarded as the potential candidates for automotive applications. The excellent combination of specific strength and ductility depends on the microstructure under different heat treatment processes of the steels. Therefore, the relationship of the combination of specific strength and ductility and microstructure should be studied in detail. Anew alloy system of aluminum-containing medium-Mn steel was developed in this study. The addition of aluminum stabilizes alpha-ferrite, and facilitates the presence of 6-ferrite during solidification. The addition of Mn and C compensates the effect of aluminum on phase stability and ensures austenite formation. In this investigation, the effects of intercritical annealing temperature on the microstructure and tensile properties of a newly designed cold-rolled aluminum-containing medium-Mn steel (0.2C-5Mn- 0.6Si- 3Al, mass fraction, %) were investigated by SEM, XRD and uniaxial tensile tests. The tensile results show that an excellent combination of ultimate tensile strength (sigma(b)) of 1062 MPa, total elongation (delta) of 58.2% and sigma(b) x delta of 61.8.% could be obtained after annealing at 730 degrees C. The inverted austenite of the cold-rolled steel coarsenes and gradually changes its morphology from mainly lamellar to mainly equiaxed with increasing intercritical annealing temperature, and a duplex microstructure consisting of multi-scale retained austenite could be obtained at 730 degrees C, which possesses suitable mechanical stability and thus presents prolonged transformation-induced plasticity (TRIP) effect during tensile deformation. This kind of sustainable TRIP effect and the cooperative deformation of ferrite are responsible for the superior mechanical properties. The investigation of tensile fracture behavior shows that the nucleation and growth of voids occurred mainly at the interfaces between soft ferrite and hard martensite induced by deformation.

Air-cooled Mn Series Bainitic Long Steel Product and Its Industrialization

Creation and development of air-cooled Mn-series bainitic steels

Creation of Air-Cooled Mn Series Bainitie Steels

The Development of Mn-Series Air-Cooled and Water-Quenched Bainitic Steels in China

Development of New Type Mn-Series Bainitic Steels in China

Prospect of air cooled bainitic steel

The Developing Prospect of Air-Cooled Bainitic Steels

Creation and Development of Novel Mn Series Air Cooled Bainitic Steels

Development of Air‐Cooled Carbide‐Free Bainite/Martensite Multiphase Steel: Transformation Kinetics, Microstructure, and Mechanical Properties

Industrial implementation of a next generation advanced high strength steel

Research on Heat Treatment of Bainitic Steel Crossing

Upgrade Rolling Based on Ultra Fast Cooling Technology for C-Mn Steel

Microstructure and Mechanical Properties of a Novel Cold Rolled Medium-Mn Steel with Superior Strength and Ductility

Research Status of High-Manganese High-Aluminum Steel and Key Points of Continuous Casting

Research on Technology for Hot Rolled Low Si-Mn Containing Nb Dual Phase Steel

Influence of Mn on microstrutcure and mecha nical properties of carbide-f ree bainitic steel

Microstructure, Tensile, and Fatigue Properties of Large-Scale Austenitic Lightweight Steel

Uncovering Microstructure–Property Relationship in Ni-Alloyed Fe–Mn–Al–C Low-Density Steel Treated by Hot-Rolling and Air-Cooling Process

Experimental and theoretical analysis of multiphase microstructure in a newly designed MnSiCrC quenched and partitioned steel to promote bainitic transformation: The significant impact on mechanical properties

Study on a Mn-Cr-Mo-La Air-cooled Bainitic Steel for Rails

Enhancing strength and ductility in heterolamellar medium-Mn steel through bamboo-like microstructure design