Abstract:A low‐carbon (0.23 wt%) carbide‐free bainitic steel is successfully developed with a total alloying addition of 4.9 wt%, which is relatively lower than alloying additions reported in similar category of steels. The present findings indicate that the currently designed low‐alloy steel composition is amenable to generation of nearly carbide‐free bainitic microstructure in large‐sized components under normal cooling conditions. Microstructures of steel after a,b) water quenching, c,d) air cooling, and e,f) furnace cooling, where bainite is obtained in both air and furnace cooled conditions. Bainitic microstructures in high‐strength steels are obtained either by continuous cooling or isothermal holding. Both scenarios necessitate faster cooling to keep the parent austenite phase untransformed till the bainite‐start temperature. The present study reports the development of bainitic microstructure in a low‐carbon steel with minimal alloying additions, under continuous cooling at very slow rates, similar to furnace cooling. For understanding the related transformation pathways, samples from the forged‐steel ingot are austenitized and cooled at different rates, viz. water quenching, air cooling, and furnace cooling. Microstructural characterization reveals development of acicular microstructures in all samples including the forged one, with gross absence of carbides. X‐ray diffraction confirms the ferritic nature of acicular plates and also indicated retained austenite present in some samples, the content of which could be correlated to the extent of bainitic transformation. Thermodynamic calculations together with microstructural observations (e.g., ferrite plate size) and hardness data established the development of fully martensitic microstructure on water quenching, while that of a mixed microstructure comprising predominantly of bainite in the forged, air cooled, and furnace‐cooled condition. The aforementioned findings could have wider implications in developing fully bainitic microstructures in large components, where uniform rapid cooling is not practically feasible.

Creation of Air-Cooled Mn Series Bainitie Steels

Creation and development of air-cooled Mn-series bainitic steels

The Development of Mn-Series Air-Cooled and Water-Quenched Bainitic Steels in China

Development of New Type Mn-Series Bainitic Steels in China

Creation and Development of Novel Mn Series Air Cooled Bainitic Steels

The Developing Prospect of Air-Cooled Bainitic Steels

Prospect of air cooled bainitic steel

Development of Air‐Cooled Carbide‐Free Bainite/Martensite Multiphase Steel: Transformation Kinetics, Microstructure, and Mechanical Properties

Air-cooled Mn Series Bainitic Long Steel Product and Its Industrialization

Formation of Bainite in a Low‐Carbon Steel at Slow Cooling Rate – Experimental Observations and Thermodynamic Validation

Experimental and theoretical analysis of multiphase microstructure in a newly designed MnSiCrC quenched and partitioned steel to promote bainitic transformation: The significant impact on mechanical properties

Carbide-Free Bainite in Medium Carbon Steel

Review on Heat Treatment and Surface Modification Technology of High‐Strength Bainite Steels

Comparative Study on Microstructures and Properties of Mn-containing and Mn-free Bainitic Steels

Research on bainite transformation in steels

Microstructure and Properties of 1 500 MPa Economical Bainite/Martensite Duplex Phase Steel

Mn-series Low-Carbon Air-Cooled Bainitic Steel Containing Niobium of 0.02%

Low-temperature bainite in low-carbon steel

Effect of the cooling rate in the medium temperature zone on the phase transformation and microstructure of carbide-free bainitic steel

A novel bainitic steel comparable to maraging steel in mechanical properties

Research on Heat Treatment of Bainitic Steel Crossing