Abstract:After spraying, the cooling medium retains potential cooling capability and, consequently, can form a falling film to further cool the downward area. In this paper, the flow patterns and the heat transfer coefficients are correlated respectively in the spray zone and the falling film zone on a vertical semi-cylindrical heating surface. The incident angle of spray (0°~45°), the spray distance (2 mm~6 mm) and the spray pressure (1 bar~5 bar) are varied in the experiments. In the spray cone, as the recirculation region which varies with different parameters shrinks, the heat transfer coefficient tends to increase. For the falling film zone, if the loss rate of the liquid is low, the flow speeds in the falling films can be compared directly by examining the film thickness. As the film thickness is reduced, the flow speed in the film is increased, resulting in the higher heat transfer coefficient. The angle of 30° is the most effective to exploit the cooling capability of the two zones. In most cases, the cooling medium after spraying can still cool the surface by the equivalent of at least 40% cooling capability of the spray zone, which indicates significant potential cooling capability which could be developed in whole spray cooling systems. An empirical correlation is presented to estimate the cooling capacity ratio on spray and falling film zone. These results may be helpful when undertaking innovative design of a spray and falling film cooling facility.

Interfacial Evaporation of Falling Liquid Films with Wall Heating

The Effect of Interfacial Evaporation on Heat and Mass Transfer of Falling Liquid Film

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Experimental study on the dryout heat flux of falling liquid film

Thermal Imaging Study of Falling Liquid Films

Study on evaporation induced flow characteristics and interfacial phenomena of water in a sidewall-heated cylindrical pool at low pressures

Mass transfer characteristics of the high temperature falling film evaporation over a vertical wall under countercurrent laminar airflow

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

Thin liquid film flow and heat transfer under spray impingement

Experimental Study on a Spray and Falling-Film Cooling System

Study on the Temperature Distribution of Heated Falling Liquid Films

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Numerical simulation of oscillatory falling liquid film flows

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Study of the Heat Transfer in Evaporating Falling Film of Fatty Acids

Technical Note on the Effect of Lateral Thermal Convection on Freely Falling Liquid Film Flow

The Effect Of Capillary Pressure For Concave Liquid-Vapor Interface On Interfacial Evaporation

Study on Shrinkage Characteristics of Heated Falling Liquid Films

Energy analysis of evaporating thin falling film instability in vertical tube

Impingement dynamics of droplets on mildly heated walls at initial and later stages