Abstract:Investigating film rupture behavior is significant but remains challenging for non-isothermal falling film absorption such as liquid desiccant dehumidification. This study captured and analyzed more than 15,000 sets of break-up patterns, and the distribution of film thickness and surface temperature across the entire falling film during liquid–gas convective absorption, with special attention to the characteristics near break-up points. The Marangoni effects, caused by surface temperature gradients, were also evaluated. Improved laser-induced fluorescence technique was employed, in which fluorescence images of film thickness were taken from the back of film substrate, and infrared thermal images were taken from the air channel side, avoiding the influence of channel vibration and reflection caused by air flow. The operating temperature of lithium chloride solution and air were 25 ∼ 60 °C and 25 °C respectively. Results show that for non-isothermal falling film, surface solitary waves play a decisive role in film break-up as most rupture occur near the crests of solitary waves. Break-up points can be classified into fixed and unfixed ones. Fixed points and associated dry areas persist in the flow due to the consistent temperature gradients on both sides of the point, which is the main cause of the reduced mass transfer. Unfixed break-up points can be rewetted by flow, but their presence still causes performance fluctuations as their positions shift laterally during falling film. Increasing the liquid temperature can increase the absorption driving force. However, when solution/substrate temperature difference is insufficient high, the enhanced Marangoni effect will promote solitary waves and both types of break-up points increase. The recommended difference in internally heated falling film regenerators should be higher than 15 °C to enhance film spreading and mass transfer. Increasing countercurrent airflow can improve mass transfer by reducing the film thickness without exacerbating the film rupture. This study explores falling film rupture behavior with flowing air, improving understanding of film dynamics and liquid–gas transfer, valuable for optimizing operational conditions in practical falling film absorption designs.

Thermal Imaging Study of Falling Liquid Films

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Study on the Temperature Distribution of Heated Falling Liquid Films

Study on Shrinkage Characteristics of Heated Falling Liquid Films

A New Insight into Marangoni Effect in Non-Isothermal Falling Liquid Films

Influence of Marangoni Effect on the Liquid Distribution of Falling Liquid Films

Influence of Marangoni Effect on Heated Falling Films

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Interfacial Evaporation of Falling Liquid Films with Wall Heating

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Piv application for the investigation of isothermal liquid film flow falling down an inclined plate

Characterization of Marangoni Effect in Non-Isothermal Falling Liquid Films of Binary Mixtures

Infrared Thermography Investigation of an Evaporating Water/Oil Meniscus in Confined Geometry.

Thin liquid film flow and heat transfer under spray impingement

Technical Note on the Effect of Lateral Thermal Convection on Freely Falling Liquid Film Flow

Investigation on film break-up behavior and the Marangoni effect during non-isothermal liquid/gas falling film absorption

Heat Transfer and Marangoni Effect of an Aqueous Electrolyte Heated Falling Film

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Spreading and splashing of liquid film on vertical hot surface by inclined jet impingement