Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Study on the Temperature Distribution of Heated Falling Liquid Films

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Thermal Imaging Study of Falling Liquid Films

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

Study on Shrinkage Characteristics of Heated Falling Liquid Films

Thin liquid film flow and heat transfer under spray impingement

Interfacial Evaporation of Falling Liquid Films with Wall Heating

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Characterization of Marangoni Effect in Non-Isothermal Falling Liquid Films of Binary Mixtures

Falling Film Flow of a Viscoelastic Fluid along a Wall

Falling Film Flow and Heat Transfer of Cryogenic Liquid Oxygen on Different Structural Surfaces

Experimental and Numerical Study on Liquid Film Cooling Performance under Heated Wall Condition

Numerical simulation of the behavior of falling films on horizontal plain tubes

Experimental study on the dryout heat flux of falling liquid film

Analysis on stability of thin falling liquid film along a heated vertical surface

Simulation of Marangoni Effect on Falling Liquid Film Flow

Modelling of evaporative falling-film heat transfer over a horizontal tube

Experimental research on falling film flow and heat transfer characteristics outside the vertical tube