Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Study on Shrinkage Characteristics of Heated Falling Liquid Films

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Study on the Temperature Distribution of Heated Falling Liquid Films

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Influence of Marangoni Effect on Heated Falling Films

Close-contact Melting of Shear-Thinning Fluids

Thin liquid film flow and heat transfer under spray impingement

Influence of Marangoni Effect on the Liquid Distribution of Falling Liquid Films

A New Insight into Marangoni Effect in Non-Isothermal Falling Liquid Films

Thermal Imaging Study of Falling Liquid Films

Thermal Imaging Study on the Surface Wave of Heated Falling Liquid Films

Rivulet Formulation in the Flow of Film Down a Uniformly Heated Vertical Substrate

Falling Film Flow of a Viscoelastic Fluid along a Wall

Analysis on stability of thin falling liquid film along a heated vertical surface

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Characterization of Marangoni Effect in Non-Isothermal Falling Liquid Films of Binary Mixtures

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

The Mechanism of Flow Patterns and Rivulet Instability in Gravity-Driven Film Flow on a Porous Wall with Uniform Heating

Film Boiling in Laminar Boundary-Layer Flow along a Horizontal Plate Surface