Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Study of the Heat Transfer in Evaporating Falling Film of Fatty Acids

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Heat Transfer Characteristics of Falling Film Evaporation on Horizontal Tube Arrays

Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator

Experimental study on enhanced heat transfer tubes in falling film evaporation

Experimental Study of the Falling Film Evaporative Cooling on Horizontal Tubes Plates

Three-dimensional heat transfer coefficient distributions in horizontal tube falling film evaporation

Experimental research on falling film flow and heat transfer characteristics outside the vertical tube

Modelling of evaporative falling-film heat transfer over a horizontal tube

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Progress of Study on Heat Transfer of Falling Film Evaporation on the Vertical Tube

The Effect of Interfacial Evaporation on Heat and Mass Transfer of Falling Liquid Film

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Establishment of the falling film evaporation model and correlation of the overall heat transfer coefficient

Experimental study on the dryout heat flux of falling liquid film

Experimental Study and Numerical Simulation on Falling Film Thickness Outside a Horizontal Tube

Experimental Study on a Spray and Falling-Film Cooling System

Interfacial Evaporation of Falling Liquid Films with Wall Heating

Falling film flow and heat transfer on a horizontal tube under the shearing of vertical vapor