Abstract:High temperature air combustion (HTAC) is a promising technology for energy saving, flame stability enhancement and NOx emission reduction. In a conventional HTAC system, the combustion air is highly preheated by using the recuperative or regenerative heat exchangers. However, such a preheating process is difficult to implement for pulverized fossil fuel fired boilers. In this paper, an alternative approach is proposed. In the proposed HTAC system, a special burner, named PRP burner is introduced to fulfill the preheating process. The PRP burner has a preheating chamber with one end connected with the primary air and the other end opened to the furnace. Inside the chamber, gas recirculation is effectively established such that hot flue gases in the furnace can be introduced. Combustible mixture instead of combustion air is highly preheated by the PRP burner. A series of experiments have been conducted in an industrial scale test facility, burning low volatile petroleum coke and an anthracite coal. Stable combustion was established for burning pure petroleum coke and anthracite coal, respectively. Inside the preheating chamber, the combustible mixture was rapidly heated up to a high temperature level close to that of the hot secondary air used in the conventional HTAC system. The rapid heating of the combustible mixture in the chamber facilitates pyrolysis, volatile matter release processes for the fuel particles, suppressing ignition delay and enhancing combustion stability. Moreover, compared with the results measured in the same facility but with a conventional low NOx burner, NOx concentration at the furnace exit was at the same level when petroleum coke was burnt and 50% less when anthracite was burnt. Practicability of the HTAC technology using the proposed approach was confirmed for efficiently and cleanly burning fossil fuels.

Development of Self-Regenerative High Temperature Air Combustion Technology

INVESTIGATION OF HIGH TEMPERATURE AIR COMBUSTION OF SELF-REGENERATOR

Experiments on Self-Regenerative High Temperature Air Combustion

Optimum Design of Contiguous Regenerator Burner

Design and Experimental Study of a New Type Self-heat-storage Burner

Application and development of regenerator material of HTAC

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

The Development of Regenerative Mill Furnace and It's Merits and Demerits

The Merits and Demerits and Combustion Thermo-Atmosphere of Regenerative Mill Furnace

Advances in Research on Combustion Characteristics Involved in High Temperature Air Combustion Technique

Continuous supercritical hydrothermal combustion experimental and burner structure optimization simulation study

Development of High Temperature Air Combustion Technology in Pulverized Fossil Fuel Fired Boilers

Feasibility and Pressure Dynamics of Novel System for Generating High Temperature Air

Study on characteristics of regenerative high temperature air production

Design of Exhaust Heat Utilization System for Shuttle Kiln

Research On An Approach To High Temperature Flameless Combustion Technology Of Biomass

A Comprehensive Heat-Equilibrium Analysis of Swiss-Roll Combustor and Its Thermal Energy Utilization System

Recent Progress in Flame Stabilization Technologies for Combustion-Based Micro Energy and Power Systems

Combustion Characteristics of Low Calorific Gas in Reciprocal Flow Porous Media Burner

Review on an Advanced Combustion Technology: Supercritical Hydrothermal Combustion

Combustor technology of high temperature rise for aero engine