Abstract:Natural gas, known for its high combustion efficiency and low CO 2 emissions, is experiencing a significant increase in both market share and application range. Despite these advantages, there are also challenges emerged during the combustion process, including occurrence of high flame temperature, difficulty in controlling nitrogen oxide emissions, combustion instability, and a tendency to backfire. To address these issues and achieve clean and stable burning, a novel 14MW water-cooled pre-mixed burner has been developed. In-depth simulations are conducted to assess the impact of various structural and operating parameters on combustion and pollutant emission characteristics. Results indicate that the combustion temperature follows a "W" shape with height of the low cooling component while its width governs combustion stability. Gas inlet spacing influences the flame center position and anti-backfire performance. The flare angle of gas channels determines the minimum ignition energy of the mixed gas fuel which affects ignition point and flame center position. Although large height of high cooling component contributes to low NO x emissions at the gas outlet, the resultant low temperature is undesirable for combustion stability. Further examinations of operating parameters through simulations reveal that combustion temperature initially decreases and then increases with excess air coefficient, while a significant decrease is noted with lower operating load. The premixed water-cooled technology could achieve low-NO x emissions to 2.89 mg·Nm -3 with the combustion temperature controlled at 1642K. This study provides valuable data for the design of low-NO x gas burners, serving as a reference for achieving clean and stable combustion of gas fuel.

Optimum Design of Contiguous Regenerator Burner

Experimental and Numerical Study of a Two-Stage Swirl Burner

TEST STUDY ON OUTLET FLOW FIELD PERFORMANCE FROM WAVE-SHAPED COMBUSTION-STABILIZING BODY OF THE CONCENTRATION TUNABLE RICH/LEAN BURNERS

Design and Experimental Study of a New Type Self-heat-storage Burner

INVESTIGATION OF HIGH TEMPERATURE AIR COMBUSTION OF SELF-REGENERATOR

Development of Self-Regenerative High Temperature Air Combustion Technology

Experiments on Self-Regenerative High Temperature Air Combustion

Numerical simulation research of the self-regenerative burner furnace heating characteristics

Numerical Investigation on 3D Unsteady Fluid Flow and Heat Transfer in a Regenerator

Numerical Simulation of Temperature Field in Blast Furnace Gas Regenerative Furnace

Emission Characteristics And Axial Flame Temperature Distribution Of A Circumferential Reverse Flow Combustor

Experiment and numerical study on combustion characteristics of low-nitrogen burners

Investigation of NOx emission under different burner structures with the optimized combustion model

Optimization of coal reburning in a 1MW tangentially fired furnace

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Numerical Studies of a Water-cooled Premixed Burner for Low NOx Combustion of Natural Gas

Combustion Characteristics of Low Calorific Gas in Reciprocal Flow Porous Media Burner

Continuous supercritical hydrothermal combustion experimental and burner structure optimization simulation study

Optimization Design on Single Stage Regenerators for Various Working Conditions

The Structural Design of and Experimental Research on a Coke Oven Gas Burner

B109 EMISSION CHARACTERISTICS AND AXIAL FLAME TEMPERATURE DISTRIBUTION OF A CIRCUMFERENTIAL REVERSE FLOW COMBUSTOR(Combustion-3)