Abstract:The open absorption system can recover water and latent heat from industrial flue gases with a higher return water temperature than conventional condensing boilers. In spite of the high efficiency, there are still a lot of unsolved problems in real applications, including the steady operation control and the optimal parameter selection. In this paper, we established a whole-cycle simulation model of a flue-gas-driven open absorption system, which was validated by various experiments to be capable of predicting the operating states of every working fluid for all kinds of actual conditions. Based on this model, we analyzed the actual performance of the system with varying temperatures, flow rates and humidity in a large range. We found that the balance between the vapor absorption and vapor generation is crucial for the optimal operation of the system. The real-time flow rate of the circulating solution should be adjusted with the varying working conditions to achieve the optimal system performance. We further proposed an optimized system based on the theoretical analysis, which can enhance the overall performance by redistributing the circulating solution within the system. The optimized scheme was well demonstrated by experiments with different flue gas humidity ratios. Compared with the original system, the heat recovery and the water recovery of the optimized one were increased by 3.0-23.8% and 5.1-41.4%, respectively, when the split ratio (flow rate ratio of the regenerating solution and the spraying solution) was varied between 0.8 and 0.2. The whole-cycle simulation results and the proposed optimization scheme will evidently contribute to the efficiency improvement of industrial waste heat recovery.

Design of Exhaust Heat Utilization System for Shuttle Kiln

Heat Transfer Ability Calculation of High-efficiency Regenerator of High Temperature Air Combustion System in Shuttle Kiln

Feasibility Analysis of the HTAC Technology Used in Shuttle Kiln

Design and Optimization of a Novel High Temperature Heat Exchanger for Waste Heat Cascade Recovery from Exhaust Flue Gases

Stress Study on Different Designs of Ceramic High Temperature Heat Exchangers

Numerical Study of Particle Behaviours and Heat Transfer in a Complex Rotary Kiln

Simulation of Honeycomb Ceramic Heat Transfer in High Temperature Air Combustion System

Performance Analysis and Optimization of Flue Gas Waste Heat Recovery System of a 600MW Coal-Fired Power Plant

Design requirements and performance optimization of waste heat recovery systems for rotary kilns

THE OXYGEN-RICH COMBUSTION TECHNOLOGY IN THE SHUTTLE KILN APPLICATION

Initial Analysis on Flue Gas Waste Heat Utilization System in Power Plant

APPLICATION OF OXYGEN-ENRICHED COMBUSTION TECHNOLOGY IN CERAMIC KILN

Advances in Research on Combustion Characteristics Involved in High Temperature Air Combustion Technique

An experimental study and computational validation of waste heat recovery from a lab scale ceramic kiln using a vertical multi-pass heat pipe heat exchanger

Waste Heat Recovery in the Coal-Fired Power Generation Integrated with Post-Combustion

Waste heat recovery from coal-fired boiler flue gas: Performance optimization of a new open absorption heat pump

Mathematical simulation of the flue-gas recovery system for coal-fired boilers based on the direct-contact heat exchanger

Waste Heat and Water Recovery from Natural Gas Boilers: Parametric Analysis and Optimization of a Flue-Gas-driven Open Absorption System

Performance Analysis and Parameter Optimization of Dual Pressure Waste Heat Recovery Generation System

Techno-economic analysis on a new conceptual design of waste heat recovery for boiler exhaust flue gas of coal-fired power plants

Performance research on the new integrated system of wet phase transition agglomeration dust collector, water saving and flue gas waste heat recovery