Abstract:The present study focuses on the impact of lipid content (1.5, 13.8, and 26% (w/w)) and pretreatment of dairy concentrates (air incorporation by whipping prior to spray-drying) on the physicochemical and technofunctional characteristics of dairy powders. Spray-drying was performed according to the following conditions: 200 °C inlet air temperature and 85 °C outlet air temperature. Physicochemical properties (particle size distribution, shape factors, moisture content, water activity, and surface composition) of spray-dried powders were characterized in order to explain their reconstitution properties and flowability.The first part of the study revealed that changing the lipid content induced no significant difference of powder reconstitution. It was evidenced that mean particle size of fatty powders was higher, thus counteracting the negative effect of powder surface hydrophobicity on its reconstitution behavior. Air incorporation in feed dairy concentrates did not significantly affect powder reconstitution properties, even if surface lipid content and mean particle size were both decreased. Standard wettability and dispersibility tests were not relevant to evaluate the reconstitution ability of investigated powders and all studied powders were classified as non-wettable and poorly dispersible.The second part of the study revealed that changing the lipid content induced a decrease in powder flowability both in unconfined conditions and under high normal stress. Powders were cohesive due to their low mean particle size and their surface lipid coverage, nevertheless feed concentrates aeration induced an improvement of powder flowability by the decrease in surface lipid content. The bulk density (BD) and the compressed bulk density (CBD) both decreased with the lipid content, and the aeration of feed concentrates did not impact the BD but led to a decrease in CBD. Last, the compressibility increased with the lipid content and the aeration of feed concentrates, as the latter induced the formation of smaller particles.

A Monodisperse Spray Dryer for Milk Powder: Investigation of Particle Shrinkage and Puffing

comparing different single milk droplet drying process WITH SPRAY DRYING PROCESS

Development of In-Line Measurement Techniques for Monitoring Powder Characteristics in a Multi-Stage Spray Drying Process

Particle morphology and shrinkage in spray dryers: A review focused on modeling single droplet drying

Mobilized blood cells vs bone marrow harvest: experience compared in 171 donors with particular reference to pain and fatigue

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Energy Saving on Spray Drying Process by Modifying the Hot Air Flow

Differences in Physicochemical Properties and Proteomics Analysis of Spray- and Freeze-Dried Milk Powders from Bovine, Goat, and Horse Sources

Impact of formulation on reconstitution and flowability of spray-dried milk powders

Particle morphology and powder properties during spray drying of maltodextrin and whey protein mixtures

Heat Transfer in a Novel Microwave Heating Device Coupled with Atomization Feeding

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Three-Dimensional Spray-Drying Model Based on Comprehensive Formulation of Drying Kinetics

Numerical Models For Viscoelastic Liquid Atomization Spray

Experimental Investigation of Spray Drying Breakup Regimes of a PVP-VA 64 Solution Using High-Speed Imaging

Effect of droplet collisions on evaporation in spray-drying

Recent initiatives in effective modeling of spray drying

Mechanistic Formulation Design of Spray-Dried Powders

Data-Driven Modeling of the Spray Drying Process. Process Monitoring and Prediction of the Particle Size in Pharmaceutical Production

Three-Dimensional Simulation Of Effervescent Atomization Spray

Describing the Drying and Solidification Behavior of Single Suspension Droplets Using a Novel Unresolved CFD-DEM Simulation Approach