Abstract:Accurate modeling of the flow field by means of capturing turbulence is crucial in CFD simulations. However, choosing the appropriate turbulence model remains quite challenging for simulating spray drying applications. Only a few studies have touched on this issue, although experimentally validated comparisons throughout the dryer are rare. This work aims to provide an assessment of five different turbulence models (RNG k−ε, standard, BSL and SST k−ω as well as transition SST) in terms of the predicted flow field throughout a lab-scale counter-current spray dryer. None of the tested models could initially provide a satisfactory match with locally measured temperatures within the chamber. The popular choice RNG k−ε model led to highest discrepancies, while the k−ω variants performed only slightly better. All these models under-predicted the dissipation of the central hot air jet. Modification to the k−ω variant’s characteristic constant to allow increased production of turbulence led to satisfactory agreement between the measurements and simulation results. Extended analysis revealed that different turbulence models produced significantly different drying histories. Only the k−ω SST variant with modified constant could provide predictions close to measured outlet particle moisture content and air conditions. The RNG model proved unsuitable due to unrealistic results with particle injection as well. The differences in predictions with injection among the models were attributed to different transient self-sustained air fluctuation behavior predicted within the chamber. This work will be useful in the selection of turbulence models which is fundamental to accurate CFD modeling of spray dryers.

Recent initiatives in effective modeling of spray drying

On the Applicability of the Coarse Grained Coupled CFD-DEM Model to Predict the Heat Transfer During the Fluidized Bed Drying of Pharmaceutical Granules

An Overview of the Recent Advances in Spray-Drying

Three-Dimensional Numerical Investigation of a Mono-Disperse Droplet Spray Dryer: Validation Aspects and Multi-Physics Exploration

Three-Dimensional Spray-Drying Model Based on Comprehensive Formulation of Drying Kinetics

On the Importance of Droplet Shrinkage in CFD-modeling of Spray Drying

On the Effect of Turbulence Models on CFD Simulations of a Counter-Current Spray Drying Process

Modeling on Effervescent Atomization: A Review

Identification of Regions in a Spray Dryer Susceptible to Forced Agglomeration by CFD Simulations

Particle morphology and shrinkage in spray dryers: A review focused on modeling single droplet drying

Recent Advances in Spray Drying Relevant to the Dairy Industry: A Comprehensive Critical Review

Computationally inexpensive simulation of agglomeration in spray drying while preserving structure related information using CFD

Multiscale Modeling for Surface Composition of Spray-Dried Two-Component Powders

Manufacturing Better Quality Food Powders from Spray Drying and Subsequent Treatments

Mechanistic Formulation Design of Spray-Dried Powders

Three-dimensional modelling of two-phase flow and transport in a pilot centrifugal spray dryer

A Three-Dimensional Numerical Study of the Gas/Particle Interactions in an Industrial-Scale Spray Dryer for Milk Powder Production

Numerical Study of the Drying Process of Different Sized Particles in an Industrial-Scale Spray Dryer

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

A meticulous overview on drying-based (spray-, freeze-, and spray-freeze) particle engineering approaches for pharmaceutical technologies

Reduction of a model for single droplet drying and application to CFD of skim milk spray drying